315652
5
Zoom out
Zoom in
Previous page
1/6
Next page
Clean the HEPA
Important:
When using the HEPA FILTER
SYSTEM, do not forget to remove
the air outlet foam filter and the
micro-active filter.
Remove the filter cartridge. Remove the
HEPA filter.
Change it every 9 to 12 months
(depending on the frequency of use).
Clean ARTEC.
Wipe the body of the appliance and
the accessories with a soft, moist
cloth, then dry.
Do not use strong or abrasive
cleaning products.
TO STORE ARTEC
•Press the pedal until the cord is
completely rewound. The plug
positions itself in its cavity.
Store accessories.
Place it in an upright position and
slide the mount on the combination
nozzle into the tube holder.
Subject to modifications!
FOR YOUR SAFETY:
Read the instructions for use
carefully and keep them in a safe
place.
Your vacuum cleaner is an electrical
appliance: it must only be used
under normal operating conditions.
The appliance should be used and
stored out of the reach of children.
Never leave the appliance
unattended when it is switched on.
The appliance is not intended for use by
young children or infirm persons without
supervision.
Young children should be supervised to
ensure that they do not play with the
appliance.
Always keep nozzles and tube ends
well away from eyes and ears.
Make sure that the operating
voltage of your vacuum cleaner is
the same as your supply voltage -
230-240v.
Unplug the appliance by removing
the plug from the power outlet:
- immediately after use
- before changing accessories
- before maintenance, cleaning or
changing the dustbag
Do not vacuum wet surfaces, any
kinds of liquids, hot substances, ultra-
fine substances (plaster, cement, ash,
etc.) large sharp debris (glass),
dangerous products (solvents,
stripping compounds, etc.), chemical
products (acids, cleaners, etc.),
inflammable or explosive products
(petrol- or alcohol-based).
Do not immerse the appliance in
water or store it outdoors.
Do not use the appliance:
- if it has been dropped and shows
signs of damage or functions
abnormally.
- if the supply cord is defective
In this case do not open the
appliance and call our helpline
(overleaf).
Repairs should only be carried out
by specialists using original
replacement parts. It is dangerous
to try to repair an appliance by
yourself. Vacuum cleaner supply
cords and winding systems must, in
all cases, be replaced by an
approved Service Centre.
In accordance with current
regulations, before disposing of an
appliance no longer needed, the
appliance should be made non-
operational (by unplugging it and
cutting off the electricity supply
cord).
Appliances equipped
with an infrared remote
control contain alkaline
batteries. Do not throw
these away with
household garbage:
dispose of them at a
suitable facility.
The company cannot accept
responsibility for damage arising
from professional use, improper use
or failure to comply with the
instructions for use. The guarantee
will be invalidated.
Your appliance conforms to the
73/23 EEC and 89/336 EEC
directives.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rowenta ro-320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rowenta ro-320 in the language / languages: English as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info