625562
44
Zoom out
Zoom in
Previous page
1/46
Next page
NX SERIES V0913 43
English
Adjusting the brake of the saw motor
If the run down time of the saw motor exceeds 10 seconds, then the brake will need to be readjusted.
This is done as follows: without removing the motor cowling, turn the bolt holding the ventilator fan on
the motor axle one 1/16th of a turn clockwise and make a brake test.
When needed adjust the brake furthermore untill it does not exceed 10 seconds.
The air gap between ventilator fan (brake disk) and brake liner (Ferrodo) is factory set at 0,25 mm, this
under normal conditions.
1 Motor frame
2 Key
3 Spring
4 Motor axle
5 Air gap
6 Electromagnet
7 Mobile disk
8 Locking nut
9 Adjustment bolt
10 Washer
11 Braking disk cast iron
12 Brake liner (Ferrodo)
44


Need help? Post your question in this forum.

Forumrules
1

Forum

robland-nxsd-410

Reset search

  • joiner works but when I lift tables out of the way for changing the thickness, the motor will not start Submitted on 22-8-2018 at 16:37

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland NXSD 410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland NXSD 410 in the language / languages: English as an attachment in your email.

The manual is 1,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NXSD 410

Robland NXSD 410 User Manual - German - 100 pages

Robland NXSD 410 User Manual - Dutch - 100 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info