592286
3
Zoom out
Zoom in
Previous page
1/44
Next page
HRA-1750D+BT - REMOTE CONTROL
Installation of Battery
1. Remove the insulating mylar strip from the battery. It is located at the bottom
back side of the remote control.
2. 2. Loosen the screw on the battery compartment cover with a screwdriver.
Pull out the battery compartment with your fingernails.
3. Replace a new battery (size 2025) correctly and fully insert the battery compar-
tment back to the original position. Tighten the screw with a screwdriver.
Handling the Remote Control
• Remove the batteries if the remote control is not going to be used for an extended
period of time.
To avoid possible failure, read the following instructions and handle the remote
control properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under the direct sunlight or near sources of excessive heat.
Do not use caustic cleaners ( porcelain, stainless steel, toilet, or oven cleaner etc. ) on the
remote control, as it may suffer damage.
Note:
Remove the battery from remote control handset when it is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.
Connecting the AC Power Cord
Connect the AC~ socket on the main unit to power plug
to the wall outlet with an AC power cord.
Caution:
Be sure to unplug the power plug from the
outlet when going out or when the unit is not in use for an extended period of time.
Connecting the DAB/FM Antenna
1. Connect the supplied DAB/FM Antenna to the DAB/FM Antenna socket on the rear of the
unit.
2. If reception is poor, connect the outside antenna.
Note:
Before attaching a 75 ohm coaxial lead (the kind with a round wire going to an outside
antenna), disconnect the supplied DAB/FM wire antenna.
Caution:
To avoid noise, keep
Antenna away from the unit, the connecting cables and the mains cable.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Roadstar HRA-1750D BT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Roadstar HRA-1750D BT in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info