528640

Roadstar CLR-2981MP Manual

4
Zoom out
Zoom in
Previous page
1/22
Next page
EnglishEnglish
34
COMPACT DISC OPERATION
• To remove a disc from its storage case, press down on the centre of the case and lift the
disc out, holding it carefully by the edges.
• Fingerprints and dust should be carefully wiped off the disc's recorded surface with a
soft cloth. Unlike conventional records, compact discs have no grooves to collect dust
and microscopic debris so gently wiping with a soft cloth should remove most particles.
Wipe in a straight line from the inside to the outside of the disc. Small dust particles and
light stains will have absolutely no effect on reproduction quality.
• Never use chemicals such as record sprays, antistatic sprays, benzine, or thinners to
clean compact discs. These chemicals can irreparably damage the disc’s surface.
• Discs should be returned to their cases after use. This avoids serious scratches that
could cause the Laser pickup to skip.
• Do not expose discs to direct sunlight, high humidity, or high temperatures for extended
periods. Long exposure to high temperatures can warp the disc.
• Do not stick paper or write anything with a ballpoint pen on the label side of the disc.
CD OPERATION
Loading and Unloading Compact Discs
1. Press the Function Selector (10) to the CD Position.
2. Press the Door Open button (22) to open the disc compartment (16).
3. When the door has opened, remove a disc from its case and place it carefully in the
compartment with the label side facing up. Locate 3” discs, on the central spindle in the
compartment.
4. Close the door by pressing on the corner of the disc compartment door.
PLAY BACK
1. Load a CD into the disc compartment, and close the compartment.
2. Press the Play/Pause (23) button. The Play/Prog indicator (26) will light up and disc play
POWER SUPPLY
This unit operates from a main supply of 230V ~ 50Hz. Connect the AC power cord to the AC
household main outlet. Ensure that the voltage is as indicated on the rating plate on the rear
of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time and alarm settings in
the event of a temporary power interruption.
Install a 2 x UM4 Battery, not included, into the battery compartment located on the back of the
unit (29).
Note:We recommend an alkaline battery for longer usable life. Change the battery every 9 to
12 months for best result and avoid possible battery leakage.
If power is temporarily interrupted the display will blink and the radio will not play. However,
the battery back-up circuit will continue to maintain the clock and alarm settings. When power
is restored the clock will display the correct time and alarm settings, and no adjustment is
necessary.
Note:If power is interrupted and there is no battery in the compartment or the battery is
exhausted. The time and alarm settings will be lost. When power is restored the clock
will begin to flash indicating that the time and alarm settings must be corrected.
RADIO OPERATION
1. Press the Stand-By / Alarm Off button (31)
2. Press the Function Button (10) to select the FM or MW RADIO Band.
3. Tune to the desired radio station by turning the Tuning control (7).
4. Adjust the Volume (2) control to the desired level.
5. To turn off the radio, Press the Function Button (10) to the OFF position.
Antenna
For FM reception there is a wire FM antenna (28) at the rear of the unit. Extend the antenna
and move it around to obtain the best reception.
For MW reception the signals are picked up through a built-in ferrite antenna. Your may have
to orient the unit to obtain the best reception.
FM Stereo and Mono Reception
The FM Stereo indicator (3) will light up when stereo signals are received.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Roadstar CLR-2981MP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Roadstar CLR-2981MP in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info