774033
8
Zoom out
Zoom in
Previous page
1/9
Next page
10 11
10. Theintensitycanbeincreasedtolevel10
by pressing the ON/UP button.
11. To decrease the intensity simply press
theOFF/DOWNbutton.
12.Change the mode by pressing the
M button on the remote control or
alternatively by pressing the MODE
buttonontheheadsetcontrols(withuse
ofamirror).
13. ToturnofftheunitpresstheOFF/DOWN
button on the remote control or headset
controls until the pulses stop.
14. Ensure that the remote control switch
is in the OFF ( O ) position to avoid
wearing the batteries down.
15.Afterusereplacethetransparentplastic
gel pad backings.
Note: If the unit is not used for a long
period of time, it is advised that you
remove the batteries until future use.
TREATMENT CONTINUED...
M
ON/UP OFF/DOWN
M
ON/UP OFF/DOWN
M
ON/UP OFF/DOWN
RC
OI
O
M
ON/UP OFF/DOWN
NO PULSE
• No battery installed-Insertbatteries.
• Wrong battery polarity-Followtheinstructionsonpage5.
• Low battery-Replacewithnewbatteries-alwaysreplace
left and right batteries at the same time.
LEDNOTFUNCTIONINGCORRECTLY
• Circuit not working properly - Remove battery for
1minute.Thenreplacebatteryandtryunitagain.
• Low battery-Replacewithnewbatteries.
WEAKPULSE
• Low intensity-IncreasebypressingtheON/UPbutton.
• Low battery-Replacewithnewbatteries-alwaysreplace
left and right batteries at the same time.
• Aged gel pads-Replacethegelpads.
REDSKINAREAAFTERUSE
• Over use-Reducedurationand/orfrequencyofuse.
• Damaged or dried pad-Dampenthegelwithaverysmall
amount of water. If this does not work replace gel pads.
LOOSEATTACHMENTOFTHEPADS
• The pads are worn out-Replacepads.
TROUBLESHOOTING
UNIT MAINTENANCE
• Keep the transparent plastic pad backings and always
replace after use.
• Avoidtouchingthegelsideofthepadsasthiswillreduce
the adhesiveness of the surface.
• Youcanprolongthelifeoftheadhesivesurfaceofthepads
by applying a small amount of water to the gel.
• Gelpadslastforapproximatelysevenuses.
• Iftheunitisleftunusedforalongperiodoftime,remove
the batteries to prolong their life.
• DoNOTdissembleorrepair.Therearenouserserviceable
parts inside the unit. If you have any problems using the
product, contact our Customer Care Department.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rio Beauty Pro Lift at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rio Beauty Pro Lift in the language / languages: English as an attachment in your email.

The manual is 2.05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info