745569
19
Zoom out
Zoom in
Previous page
1/20
Next page
Fehler und Warnungen Tastendisplay
Die LED-Anzeige am Funkempfänger im Ofen zeigt verschiedene Fehler an.
Blinkt die LED Anzeige am Empfänger abwechselnd grün und rot, sind zwei Sender mit der
gleichen Stellung der DIP-Schalter im Empfangsbereich. Wählen Sie eine andere, bei Sensor und
Empfänger übereinstimmende Schalterstellung. Die LED-Anzeige geht in den Normalmodus
über und leuchtet durchgehend grün.
Blinkt bei einer Neuinstallation die LED-Anzeige am Funkempfänger immer grün, so kann
keine Verbindung zum Funkraumsensor hergestellt werden. Überprüfen Sie die Batterien
im Funkraumsensor und erhöhen Sie die Senderleistung wie im Absatz INSTALLATION
beschrieben.
Hinweis
Heizt der Ofen immer auf 25°C überprüfen Sie den DIP-Schalter 4 des Funkempfängers.
Für einen geregelten Heizbetrieb muss Schalter 4 in OFF-Position stehen.
Warnungen am Display:
Ist die Verbindung zum Raumsensor unterbrochen, wird nach ca. 10min. eine Warnung in
Laufschrift am Display ausgegeben: ROOM SENSOR SIGNAL LOST. Der Ofen wechselt in
Stand-by. Wird die Verbindung zum Raumsensor wieder hergestellt, erlischt die Warnung
automatisch und der zuvor eingestellte Betrieb wird weitergeführt.
Während der Warnung „ROOM SENSOR SIGNAL LOST“ kann der Raumsensor durch Drücken
der I/O Taste deaktiviert werden. Der Ofen geht in den Modus „HEAT“, die weitere Bedienung im
manuellen Modus ist in Ihrer Ofenanleitung beschrieben.
Maßnahmen bei Fehleranzeige:
Q Prüfen Sie die Steckverbindung vom Kabel zur Platine.
Bei Funkraumsensor zusätzlich:
Q Prüfen Sie die Batteriespannung Ihres Funkraumsensors. (Die LED am Funkempfänger im
Ofen leuchtet rot.)
Q Prüfen Sie Störfaktoren des Funksignals. Erhöhen Sie die Senderleistung, indem Sie im
Funkraumsensor den DIP-Schalter 4 auf ON stellen - siehe Installation.
DE
|19
18
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rika Raumsensor und Funkraumsensor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rika Raumsensor und Funkraumsensor in the language / languages: German as an attachment in your email.

The manual is 1,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info