626525
3
Zoom out
Zoom in
Previous page
1/28
Next page
GB
Z1209004. 5 GB
Enjoy the RIHO life-style
GB
GB
Whirlpool Electronic LCD user handbook
1.4 Pre-installation actions
The installer must ensure the presence of the following structural facilities among other things:
- Ventilation grid for the motor(s) of at least 100cm².
- A 2nd ventilation grid for natural ventilation (to the extent possible, they should be placed as far apart as
possible).
- Inspection hatch(es) of at least 40 x 50cm for service access (at least to the motors). Riho recommends
that an inspection hatch should be placed near the overflow opening.
- Hot and cold water supply.
- Water drain
- Electrical connection, one or two groups of 230V/50Hz 16Amp with earth leakage switch, dependent
on your options (option heater). Also see chapter 1.5.6
- Potential difference equalisation 6 mm² earth connection to whirlpool frame.
- Splash-proof rim around the whirlpool.
The installer should pay special attention to the following points before installing the bath:
- Check the bath and the whirlpool for possible defects before installation. No dismantling costs will be
paid in the case of defects found after installation. After installation, Riho can only give a guarantee on
hidden defects.
- When transporting and installing the bath, do not hold it by the pipes, hoses and jets.
- Check the whirlpool for leaks before installation.
- The whirlpool bath must be clear of the wall, so that unavoidable vibrations caused by the motor are not
transferred to it. The use of bath insulation tape between the bath rim and walls is recommended this will
reduce the noise level.
- If plastic panels are installed, pay attention to the height of the panel with respect to the bottom edge of
the bath. The panel should be at least 5mm from the floor, for ventilation purposes.
In case of doubt, consult a plumbing specialist.
1.2 Whirlpool installation
All Riho Whirlpool baths are made of acrylic (see description: acrylic baths) and equipped with a Whirlpool bath as per
customer's choice.
Please refer to the Riho price lists for details of all options.
1.3 Delivery:
Generally, all whirlpool systems are fully installed, functionally tested and packed.
All Whirlpool baths are supplied with a flexible PU drain-overflow, which in some cases is not fitted when delivered.
! ATTENTION! Before installation, check the bath for damage, as well as material and/or manufacturing defects. For
this remove, the cardboard packaging. In order to prevent damage during installation, allow the foil to remain as long
as possible and remove it only at the last moment. After installation, Riho can only give a guarantee on hidden material
defects. Check the foil for scratches and damage if any. If these are present, check the bath itself to see whether it is
damaged. For this, remove as little foil as necessary in order to protect the bath as properly as possible during
installation. In case of doubt, consult a plumbing specialist.
!
WARNING; make sure chrome parts don't come into contact with materials or water used to remove building materials,
such as mortar, grout or tile adhesive because of possible chemical components in the composition which can damage
the chrome surface.
THE MANUFACTURER REFUSES TO ACCEPT ANY LIABILITY IN THE FOLLOWING CASES:
- the national guidelines and standards that apply to earthing, potential difference equalising and electrical
installations in the bathroom are not adhered to.
- the description contained in the national laws and standards that apply to safety in bathrooms are not
adhered to.
- the instructions described in this manual are not adhered to.
Parts are dismantled after inspection in the factory to facilitate transport and to enable it to be carried into the
room in which it is to be installed. It is advisable to check all the components of the bath before installation.
Any damage claimed after installation will not be covered under the guarantee.
Diagram fig. 1 Safety distances.
1.0 Installation of Riho Whirlpools
The Whirlpool baths are fully in conformity with the applicable EN and national guidelines.
The installation must be fitted by a recognised installer.
The assembly and installation of the whirlpool must be done in accordance with the instructions described
in this manual.
The installer will be responsible to check that the civil, electrical and water-related pre-installation work
is done properly.
1.1 Safety regulations for bathrooms.
Electrical sockets, lamps, switches and/or other electrical equipment should be installed outside the danger zones
indicated in the national guidelines and standards. Above all, the regulations prohibit the presence of any electrical
installation within 60 cm around the bath, and less than 225 cm above it (see Fig.1). The switch and other electrical
devices should be installed so as to be inaccessible to the person using the whirlpool.
-31--30-
6
0c
m
m
2
40c
e
on
1Z
Zone
2
o
eZ
n
3
Zo e
n
2
Z
ne 3
o
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Riho Whirlpool Electronic LCD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Riho Whirlpool Electronic LCD in the language / languages: English as an attachment in your email.

The manual is 4,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Riho Whirlpool Electronic LCD

Riho Whirlpool Electronic LCD User Manual - German, Dutch - 33 pages

Riho Whirlpool Electronic LCD Usermanual and installation guide - Dutch - 28 pages

Riho Whirlpool Electronic LCD User Manual - French - 33 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info