645160

Ricatech RTT33 Manual

3
Zoom out
Zoom in
Previous page
1/16
Next page
POWER SOURCE
Unwind the power adaptor (Located in a white box inside the packaging foam). First connect the small end of
the adaptor to the back of the turntable, then the other end to an AC power outlet.
UNPACKING THE TURNTABLE
1. Remove packing materials from unit.(Note: Save all packing materials.)
2. Carefully remove unit from its styro-foam and take it out of the plastic bag.
3. Although records can be played with the lid attached and opened, it is recommended
this is removed.
4. Remove the white protective needle cover by gently pulling towards front of unit.
TURNTABLE OPERATION
1. Turn the unit on by rotating the ON-OFF VOLUME SWITCH located on the front panel to the ON position.
2.
Release TONE ARM from the ARM LOCK and place it on the ARM REST.
Important: The ARM LOCK is taller than the turntable and needs to be folded down to allow larger
records to be played.
3 Set the SPEED CONTROL SWITCH to desire speed (33 1/3,45 or 78 rpm). Place the record on the
turntable.
4. Lift the TONE ARM by hand to the record and slowly lower it to the desired starting point. The turntable
will start to turn automatically. At the end of the record, the turntable will still turn. You must return the
TONE ARM to the ARM REST manually.
5. Re-adjust the ON-OFF VOLUME SWITCH to the desired level.
NOTE: After use and before closing the cover, always place the TONE ARM back on the ARM LOCK
after this has been pushed upwards again.
ACCESSORY: Adaptor for 45 rpm record
To play the 45 rpm record, place the ADAPTOR on the SPINDLE.
1. Place the 45 RPM adaptor over the spindle.
2. Gently place your 45 RPM record onto the turntable.
3. Follow the steps under turntable operation to play your record.
NEEDLE INSTALLATION
REMOVING NEEDLE:
1. Gently pull down the tip of the cartridge.
2. Pull cartridge forward.
3. Pull out and remove.
INSTALLING CARTRIDGE:
After following ―Remove instructions‖ above, follow steps 1 to 4.
1. Position red cartridge with sapphire stylus facing down.
2. Line up the tab on the back of the needle with the tone arm (as shown in picture 1 below).
3. Insert the cartridge with its front end at a downward angle (as shown in picture 2 below).
4. Lift front end of needle upward until it snaps into place.
ADDITIONAL INFORMATION:
• The red cartridge has a very small sapphire stylus that is barely visible.Take note the replacement needle
you are receiving is the same as the needle already on the tonearm.
• This needle is safe for 33 1/3, 45 & 78 speed records.
• Replacing the needle depends on how often you use your turntable.
• This sapphire stylus will provide an average of 1000 hours playing time.
LINE OUT OUTPUTS
1. Connect the auxiliary cables(not supplied) to the LINE OUT JACK and to the auxiliary inputs on the
desired component.
2. Plug Auxiliary cable into the LINE OUT JACK on the back of your unit.
3. Plug the other end of the Auxililary cable into the input jack on your desired external component.
4. Check the volume level of your external component.
5. See operators manual for correct operation of the external component.
SUBWOOFER OUTPUT JACK
The subwoofer output jack enables you to attach a subwoofer (not supplied) which will enhance bass
response. Please contact your retailer for suitable subwoofer models.
TROUBLESHOOTING GUIDE
THERE IS NO POWER
- The AC adaptor is not connected to either a power outlet or unit.
- The unit is not turned ON : Rotate the ON-OFF SWITCH from the OFF position.
TURNTABLE WILL NOT WORK
- The white protective needle cover was not removed.
- Adjust the VOLUME CONTROL knob.
- The volume is not turned up.
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ricatech RTT33 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ricatech RTT33 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 0,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info