656685

Renkforce 1208454 Manual

4
Zoom out
Zoom in
Previous page
1/6
Next page
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2014 by Conrad Electronic SE.
Operation
Connect the consumer load to the mains socket (F).
Please consult the section “Technical Data” for the consumer load’s permis-
sible maximum power.
By using the respective “ON” or “OFF” button of the switching channel on the hand-
held radio transmitter the radio-controlled switch socket is turned on/off again with
the same set switching channel (control-LED (E) lights up or turns off).
Maintenance and Care
The product does not require any maintenance and should never be opened or disas-
sembled for any reason.
Remove connected consumer loads from the radio-controlled switch socket and re-
move it from the mains socket, before cleaning the product.
Only clean the product with a soft, clean, dry cloth. Never use aggressive cleaning
agents or chemical solutions, since they might damage the surface of the housing or
impair the function.
Handling
• The product is only to be used in closed, dry indoor locations. The product
must not get damp or wet.
• Avoid the following unfavourable environmental conditions at the installa-
tion location and during transportation:
- Excessive humidity or dampness
- Direct sunlight
- Extreme cold or heat
- Dust or flammable gases, fumes or solvents
- Strong vibrations
- Strong magnetic fields such as those found in the vicinity of machinery
or loudspeakers
• Ensure that the insulation for the entire product is neither damaged nor
destroyed. Never disassemble the product! There are no serviceable
parts inside.
• Check the product for damage before each use!
If you recognize damages, don’t use the product any longer! There is dan-
ger to life through an electric shock!
Safe operation must be presumed to be no longer possible:
- if the device is visibly damaged
- if the device no longer works
- if the device was stored under unfavourable conditions for a long period
of time
- Following considerable stress during transportation
Range
The transmission range of the radio signals, between the hand-held transmitter and
the radio-controlled switch sockets, is up to 30 m under optimum conditions.
This value, however, is the so-called “open space range” (the range when
transmitter and receiver are visible to each other, without interfering influ-
ences).
In practice, however, there may be walls, room ceilings etc. between the
transmitter and the receiver which reduce the range accordingly.
Due to the different influences on the wireless transmission, no specific
range can be guaranteed.
Nevertheless, trouble-free operation in a single-family home is usually pos-
sible.
Sometimes the range can be considerably reduced due to:
• Walls, reinforced concrete ceilings
• Coated/metallised insulated glass
• Proximity to metallic & conductive objects (e.g., heating elements)
• Proximity to human bodies
• Broadband interferences, e.g. in residential areas (DECT telephones, mobiles, radio-
controlled headphones, radio-controlled speakers, other radio-controlled weather
stations, baby phones etc.)
• Proximity to electric motors, transformers, power-supply units, computers
• Proximity to computers or other electrical devices that are improperly shielded or
operated without any cover
Disposal
a) General
Please dispose of the products when they are no longer of use, according to
the current statutory requirements.
b) Normal and rechargeable batteries
As the end user, you are required by law (Battery Ordinance) to return all used bat-
teries/rechargeable batteries; disposal of them in the household waste is prohibited.
Contaminated batteries/rechargeable batteries are labelled with this symbol
to indicate that disposal in the domestic waste is forbidden. The designa-
tions for the heavy metals involved are: Cd = Cadmium, Hg = Mercury, Pb =
Lead.
Used batteries/rechargeable batteries as well as coin cells can be returned to collec-
tion points in your municipality, our stores or wherever batteries/rechargeable batter-
ies/coin cells are sold!
You therefore fulfil your statutory obligations and contribute to the protection of the
environment!
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that
this product conforms to the fundamental requirements and the other relevant regula-
tions of the directive 1999/5/EC.
The Declaration of Conformity for this product is available at
www.conrad.com.
Technical Data
a) Hand-held radio transmitter
Transmission frequency ............ 433 MHz
Power supply .............................. 1x 12 V battery, type “23A”
Address codes............................ 4 (to be set via the sliding switch I, II, III, IV)
Switching channels ................... 4 (each with “ON” and “OFF”-button)
Range ........................................... up to 30 m (open space, see chapter “Range”)
LED................................................ lights up briefly, when the buttons are used
Operating environment ............. only suitable for enclosed, dry indoor locations
b) Radio-controlled switch socket
Reception frequency ................. 433 MHz
Operating voltage....................... 230 V/AC, 50 Hz
Protection class ......................... I
Input power ................................. 2000 W Ohm resistive load, 300 W inductive load
Address codes............................ 4 (to be set via the turn-switch I, II, III, IV)
Switching channel ..................... adjustable with turn-switch “1 2 3 4”
LED................................................ lights up, when the mains socket/consumer load is ac-
tivated
Operating environment ............. only suitable for enclosed, dry indoor locations
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Renkforce 1208454 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce 1208454 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info