616973
4
Zoom out
Zoom in
Previous page
1/71
Next page
ENGLISH
This product is not suitable for use in bath or shower.
THE HAIRDRYER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN
NOT IN USE.
Do not leave the dryer unattended when switched on.
Allow the dryer to cool down before storage.
Do not immerse in water or other liquids.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
Damaged cords can be dangerous.
In use, take care that the inlet and outlet grilles are not blocked in any way as this will
cause the unit to automatically stop. Should this occur, switch off and allow the unit to cool
down.
Ensure the inlet grille is free from obstructions such as household fluff, loose hair etc.
Do not place hairdryer on soft material e.g. carpet, bedding, towels, rugs etc.
Do not leave the dryer switched on when you set it down.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Do not direct the airow towards the eyes or other sensitive areas.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
Do not use any attachments with this hairdryer, other than those supplied by Remington
®
.
Avoid allowing any part of the hairdryer to contact the face, neck or scalp.
This appliance is not intended for commercial or salon use.
If the supply cord of this unit becomes damaged, discontinue use immediately and
return the appliance to your nearest authorised Remington
®
service dealer for repair or
replacement in order to avoid a hazard.
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other item(s),
caused by misuse, abuse or non-compliance with these instructions.
WIRING INSTRUCTIONS UK Plugs Only
This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below.
If it is necessary to replace the plug fuse, use only fuses that are approved to BS1362, rated
at 13A. If in doubt consult a qualified electrician.
ENGLISH
090178_REM_IFU_D5015_22L.indd 2 11:09:54|30.04.09 Guido Krölls
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Remington D5015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Remington D5015 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Finnish, All languages as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info