12
Inspect and tighten all parts of the exercise cycle
regularly. Replace any worn parts immediately.
The exercise cycle can be cleaned with a soft, damp
cloth. Avoid spilling liquid on the console. Keep the
console out of direct sunlight or the display may be
damaged. Remove the batteries when storing the
exercise cycle.
HOW TO TIGHTEN THE CRANK
If the arms of the Crank (27) become loose, they
should be tightened in order to prevent excessive
wear. Loosen the crank nut on the left arm of the
Crank. Place the end of a standard screwdriver in one
of the slots in the slotted crank nut. Lightly tap the
screwdriver with a hammer to turn the slotted crank
nut counterclockwise until the arms are no longer
loose. Do not overtighten the slotted crank nut.
When the slotted crank nut is properly tightened,
retighten the crank nut.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. To replace the batteries, see
assembly step 5 on page 7. In addition, make sure
that the console wire is connected to the reed switch
wire.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (16) must be
removed. Using an adjustable wrench, turn the Left
Pedal (50) clockwise and remove it from the Crank
(27). Remove the nine M4 x 25mm Screws (15) and
the two M4 x 18mm Screws (37) from the Right Side
Shield (34). Next, remove the two M4 x 18mm Screws
(37) from the Left Side Shield (16). Grasp both Side
Shields at the top and gently pull them apart. Make
sure that the arm of the Crank is in the position shown
in the drawing above. Carefully slide the Left Side
Shield forward off the arm of the Crank and remove it.
Next, locate the
Reed Switch (25).
Turn the Crank (27)
until the Reed
Switch Magnet (26)
is aligned with the
Reed Switch.
Loosen but do not
remove the M3 x
10mm Self-tapping
Screw (48). Slide
the Reed Switch
slightly closer to or away from the Magnet. Retighten
the Screw. Turn the Crank for a moment. Repeat until
the console displays correct feedback. When the
Reed Switch is correctly adjusted, re-attach the left
side shield and pedal.
MAINTENANCE AND TROUBLE-SHOOTING
Crank Nut
Slotted Crank
Nut
27
15
15
15
15
16
50
27
37
37
34
37
37
48
27
25
26
