752015
1
Zoom out
Zoom in
Previous page
1/5
Next page
1
DE Bedienungsanleitung
Lesen Sie diese Bedienungsanleitung aufmerksam durch und bewahren Sie diese sorgfältig auf um in Zukunft nachschlagen
zu können. Die Abbildungen in diese Bedienungsanleitung dienen nur der
Referenz und müssen nicht dem Original entsprechen.
GB Manual
Read these instructions carefully and keep them carefully to be able to look up in the future. The illustrations in this manual
are for reference only and do not necessarily match the original.
FR Manuel
Lisez attentivement ces instructions et de les conserver soigneusement pour être en mesure de retrouver à l'avenir. Les
illustrations de ce manuel sont fournies à titre indicatif et ne correspondent pas nécessairement à l'original.
NL Gebruiksaanwijzing
Lees deze instructies aandachtig en zorgvuldig bewaar ze in staat zijn om omhoog te kijken in de toekomst. De afbeeldingen
in deze handleiding zijn alleen ter referentie en niet noodzakelijkerwijs overeenkomen met de oorspronkelijke.
ES Usuario
Lea atentamente estas instrucciones y guárdelas cuidadosamente para ser capaz de buscar en el futuro. Las ilustraciones de
este manual son sólo de referencia y pueden no coincidir con el original.
PL Instrukcja
Uważnie przeczytać instrukcję i zachować je starannie, aby móc patrzeć w przyszłość. Ilustracje w tej instrukcji są wyłącznie
w celach informacyjnych i nie muszą odpowiadać oryginałowi.
IT Utente
Leggere attentamente queste istruzioni e di conservarle con cura per essere in grado di cercare in futuro. Le illustrazioni
contenute in questo manuale sono solo di riferimento e non corrispondono necessariamente l'originale.
DE Vorbereitung
Entfernen Sie die Pylonen aus der Halterung an der Verpackung. Nun lösen Sie das Modell unterhalb der Plattform mit
einem Schraubenzieher. Nun entfernen Sie die Fernbedienung und die Antenne aus der Fernbedienung. Anschließend
befestigen Sie die Antenne an der Fernbedienung wie abgebildet. Nun öffnen Sie die Batterieabdeckung an der Rückseite
und legen Sie 4x 1.5V AA Batterien in die Fernbedienung ein. Achten Sie hierbei auf die korrekte Polarität.
GB Preparation
Remove the pylons from the bracket on the packaging. Now solve the model under the platform with a screwdriver. Now
remove the remote control and antenna from the remote control. Then fasten the antenna on the remote control as
shown. Now, open the battery cover on the back and put 4x 1.5V AA batteries into the remote control. Pay attention to the
correct polarity.
FR Préparation
Retirez les pylônes du support sur l'emballage. Maintenant résoudre le modèle sous la plate-forme avec un tournevis.
Maintenant supprimer le contrôle et l'antenne à distance de la télécommande. Ensuite, fixez l'antenne de la télécommande
comme indiqué. Maintenant, ouvrez le couvercle de la batterie sur le dos et de mettre les piles AA de 1,5 V 4x dans la
télécommande. Faites attention à la polarité.
NL Voorbereiding
Verwijder de masten van de beugel op de verpakking. Nu lossen het model onder het platform met een schroevendraaier.
Verwijder nu de afstandsbediening en antenne van de afstandsbediening. Vervolgens zet de antenne op de
afstandsbediening zoals afgebeeld. Nu, opent u het batterijklepje aan de achterkant en zet 4x 1,5 V AA-batterijen in de
afstandsbediening. Let op de juiste polariteit.
ES Preparación
Retire las torres de alta tensión de la abrazadera en el envase. Ahora resolver el modelo bajo la plataforma con un
destornillador. Ahora quitar el mando a distancia y la antena desde el control remoto. A continuación, fije la antena del
mando a distancia como se muestra. Ahora, abra la cubierta de la batería en la parte posterior y ponga las pilas AA de 1.5V
4x en el control remoto. Preste atención a la polaridad correcta.
PL Przygotowanie
Usuń pylony z uchwytem na opakowaniu. Teraz rozwiązania modelu pod platformą śrubokrętem. Teraz wyjmij z pilota i
anteny z pilota. Następnie zamocować antenę na pilocie, jak pokazano. Teraz, otwórz pokrywę baterii z tyłu i umieścić 4x
baterie 1,5 V AA do pilota. Należy zwrócić uwagę na prawidłową polaryzację.
IT Preparazione
Rimuovere i piloni dalla staffa sulla confezione. Ora risolvere il modello sotto la piattaforma con un cacciavite. Ora
rimuovere il telecomando e antenna dal telecomando. Poi fissare l'antenna sul telecomando come illustrato. Ora, aprire il
coperchio della batteria sul retro e mettere batterie da 1,5 V AA 4x nel telecomando. Prestare attenzione alla corretta
polarità.
DE Ladevorgang
Öffnen Sie die durchsichtige Abdeckung an der Fernbedienung. Dann verbinden Sie das Kabel mit der Fernbedienung. Nun
leuchtet die nun auf und erlischt sobald das Modell geladen ist. Eine Akkuladung dauert etwa 5 Minuten.
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rayline 8002 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rayline 8002 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info