476371
5
Zoom out
Zoom in
Previous page
1/21
Next page
-19-
-4-
Foutmeldingen en andere aanduidingen op het display
Soms geeft het display een foutmelding ’Err’. Zet de RX 7020 even uit of verwijder de
batterij en zet hem weer terug om de weegschaal helemaal te resetten. Zet de
RX 7020 vervolgens weer aan.
Op het display ziet u: Dit betekent:
Alle displaysegmenten lichten tegelijk op.
Alle segmenten functioneren.
– – Sensor wordt te weinig belast (minder
dan minimale belasting).
Err Te hoge belasting (meer dan maxi-
male belasting).
LO Batterij wordt te zwak.
Err-h Het berekende vetpercentage ligt
boven het maximum van de RX 7020.
Err-l Het berekende vetpercentage ligt
onder het minimum van de RX 7020.
Informatie
Het door de RX 7020 bepaalde vetpercentage is gebaseerd op een standaard meet-
methode. Het wordt berekend volgens een formule die ontwikkeld is op basis van
uitgebreide wetenschappelijke studies. Het vochtbestanddeel in de magere spieren
beïnvloedt het meetresultaat. Individuele gewoonten en leefstijl zullen het evenwicht
van het vochtgehalte beïnvloeden.:
Na een bad kan de meting lager uitvallen.
Na het eten en/of drinken kan de meting hoger uitvallen.
Tijdens de menstruatie kunnen de metingen fluctueren.
Vochtverlies door ziekte of lichamelijke inspanningen, die hevige transpiratie en
uitdroging veroorzaken, kan uiteraard de metingen beïnvloeden.
Onderstaande tabel geeft aan wat de relatie is tussen de geschatte lichamelijke
toestand en de door de RX 7020 gemeten vet- en vochtpercentages.
Error messages and other indications on the display
Sometimes the display shows an error message ’Err’. Switch off the RX 7020 for a
moment or remove the battery and put it back to completely reset the weighing
scale. After that switch it back on.
On the display you see: This means:
All display light up simultaneously. All segments are functioning.
The sensor is undercharged (less than
minimal charge).
Err The sensor is overcharged (more than
maximal charge).
LO Low battery
Err-h The calculated body fat percentage
is above the maximum of the RX 7020.
Err-l The calculated body fat percentage
is below the minimum of the RX 7020.
Information
The body fat percentage determined by the RX 7020 is based upon a standard meas-
uring method. It is calculated by way of a formula whose development is based upon
extensive scientific studies. The hydration percentage in the lean muscles affects the
measuring result. Individual habits and lifestyle will affect the balance of the hydration level.
After a bath the reading may be lower.
After a meal or a drink the reading may be higher.
During the female menstruation period the readings may fluctuate.
Loss of water through illness or physical activities causing heavy perspiration and
dehydration, can of course affect the readings.
The table below indicates the relation between the estimated physical condition
and the body fat / hydration percentages calculated by the RX 7020.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ranex RX 7020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ranex RX 7020 in the language / languages: Dutch as an attachment in your email.

The manual is 2,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info