Manual Radson Confort Pilot (page 1 of 6) (English, Dutch, French)

500579

Zoom out

Zoom in

1/6

ENG

Guide for installation and use CONFORT PILOT

After connecting your appliance to the electrical installation,

turn on the appliance by pressing the button

[B].

The indicator light [C] will light up.

Function buttons:

A Temperature control [indicator light colours: frost

outside [*] - yellow; ECO - green; 18°C to max. - red].

Used to engage the “Confort Pilot” function.

B ON/stand-by button, thermostat and 2-hr. timer.

C Radiator control light [green indicator light].

D Indicator light for the 2-hr timer [red indicator light].

THERMOSTAT CONTROL

To select the desired [or recommended] temperature:

• Press the [+] or [-] button [A].

- The thermostat indicator light will begin to

ash if the room temperature is lower than the

desired temperature: the appliance will start.

- When the desired temperature has been

reached, the thermostat indicator light [C]

will stop ashing and will burn steadily: the

appliance will stop.

The appliance starts as soon as the room temperature

is lower than the recommended temperature.

USING THE TIMER TO ADJUST THE

TEMPERATURE

With this function, you can warm up a room or dry

laundry for 2 hours. The appliance thermostat does

not operate during that time [the recommended

temperature indicator light is off].

The timer indicator light will burn until the 2 hours

are over. The appliance will then return to normal

operation [thermostat-control of the room tempera-

ture] when the timer goes out.

To activate the timer:

• Press briey on the

button:

- The timer indicator light [D] will light up and the

2-hour heating cycle will start.

The timer indicator light will ash until the end

of the cycle.

Note: you can interrupt the timer at any time by

pressing 2 times quickly on the

button.

o activate the “Confort Pilot” function:

With this function, you can programme the timer to

repeat a specic heating function every day at the

same time.

• Activate the timer [as explained below].

• Press on the desired time by pressing the [+] but-

ton for 5 seconds to register that you are activating

it [the red indicator light will ash].

- The heating will start immediately for 2 hours

and will repeat after 23.15 hours and thereafter

every 24 hours.

Example: on the 1st morning, the user pushes the

[+] button for 5 seconds at 7.00 o’clock in timer

mode. The next day, and for every day thereafter, the

appliance will start at 6.15 a.m. and run for 2 hours.

Note:

• You can interrupt the timer at any time by pressing

2 times quickly on the

button.

• To cancel the programme, press the [+] button in

timer mode for 5 seconds.

CALIBRATING THE THERMOSTAT

A difference of 1° C to 2° C between the reference

temperature on the housing and the temperature

that is measured by a thermometer is normal.

If you want those 2 values to be identical, you can do

the following:

• Measure the room temperature with a thermo-

meter;

• Press on the

and [+] buttons for at least 5

seconds at the same time.

- The temperature indicator light and the ‘frost

outside’ indicator lights will both begin to ash.

• If the temperature on the display is not the same

as the temperature shown on the thermometer,

press the [+] or [-] button to adjust the tempera-

ture shown to match the room temperature.

• To set the new values, press briey on the

button.

• Example: the display shows 20° C and the

thermometer shows 22° C. Press the [+] button

until the display shows 22° C.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Radson Confort Pilot in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 1,59 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Radson Confort Pilot Manual

Product: