600481
2
Zoom out
Zoom in
Previous page
1/4
Next page
Main Unit:
The main unit contains the 2*6*0.5W LED, moon sensor and baery
(Ni-MH Rechargeable baery, 3.6V 2200mAh). When deciding where
to mount this unit, keep in mind that the moon sensor that acves
the light has a “field of vision” of min. 8 meters (in front of the light)
and about 130º (horizontal) at 25 environmental temperature.
Solar Cell:
The solar cell is the power source for the SOLAR PIR SENSOR LIGHT. It
converts the sun’s energy into electricity that charges the baery
stored in main unit. This requires DIRECT SUNLIGHT falling onto the
face of solar cell for as long as possible over the course of day.
Use the three screws supplied (#4 on parts list) to mount the solar
cell unit onto a solid surface. Make sure it is anchored into the solid
surface.
You can adjust the angle of the solar cell by moving the adjustment
support to the appropriate hook on the mounng bracket. Remem-
ber, it must face as much DIRECT SUNLIGHT over the course of the
day as possible. Keep in mine shadows that may block sunlight at
some point during the day.
Now carefully route the solar cell power cord to the main unit and
plug it into the connector on the side of the unit.
FINAL ADJUSTMENT AND START-UP
Aer you successfully installed your SOLAR PIR SENSOR LIGHT, you
are almost ready for carefree operaon with a few final steps:
Inial 3-days Charge:
On the main unit there is a dial switch with 2 posions:
OFF AUTO
AUTO —
Posion for normal operaon of unit.
OFF ---
1) Posion for shipping or extended periods of non-use
2) Posion for inial 3-day charge before final adjustment and first
use. (Although the unit can charge, it is not operaonal in this
mode)
For now, turn the dial switch to OFF posion. In this posion the solar
cell will charge the baery without acvang the unit. Leave the
switch in this posion for 3 sunny days to ensure that the baery has
a full charge prior to moon sensor adjustment and normal opera-
on.
OFF AUTO
2
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Qazqa 90500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Qazqa 90500 in the language / languages: English as an attachment in your email.

The manual is 1,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info