572630
7
Zoom out
Zoom in
Previous page
1/32
Next page
56
5

Установите батареи в соответствии с указаниями раздела
становка батарей".
Войдите в темную зону.
Снимите крышку объектива (2), сдвинув ее на корпус объектива.
Включите прибор, повернув рукоятку (3) в положение "ON" -
загорается индикатор зеленого цвета. При разряде батарей цвет
индикатора изменяется на красный. Это означает, что прицел будет
нормально работать с включенным ИК-осветителем до полного
разряда батарей еще около 30 минут.
Выберите неподвижный объект наблюдения, удаленный на
расстояние около 100 м.
Установите ручку фокусировки объектива (6) напротив метки "100" -
об этом свидетельствует повышенное усилие ее фиксации.
Наблюдайте выбранный объект через прицел, вращайте кольцо
фокусировки окуляра (7) до получения максимального качества
изображения.
При необходимости включите встроенный ИК - осветитель (8). Для
этого поверните рукоятку (3) в положение "IR" - загорается индикатор
красного цвета.
Поворачивайте бленду ИК - осветителя (8) до получения
необходимой фокусировки инфракрасного светового пятна.
После данной настройки, независимо от дистанции и других
условий, вращать кольцо окуляра (7) не требуется. Настраивайте
качество изображения только вращением ручки фокусировки
объектива (6) и бленды ИК - осветителя (8).
Вы также можете проверить прицел и в освещенной зоне. Этот
режим работы предусмотрен исключительно для проверки
работоспособности прибора - крышка (2) должна быть плотно
надета на объектив.
Для регулировки яркости красной прицельной метки поворачивайте
ручку (4).
Для выбора цвета прицельной метки (зеленый или красный)
нажимайте кнопку (5) до щелчка.
По окончании использования выключите прицел. Для этого
поверните рукоятку (3) в положение "OFF". Закройте крышкой (2)
объектив прибора.
Вы можете установить прицел на оружие с помощью специального
кронштейна (9). После первой установки Вашего прицела на оружие,
необходимо выполнить рекомендации раздела "Пристрелка
прицела к оружию".
Моментальное включение прицела и ИК - осветителя на охоте может
выполняться с помощью выносного пульта, подсоединенного к
гнезду (10).
BATTERY INSTALLATION
Turn the knob of the battery compartment cover 90° counterclockwise (1)
to match the red dot on the knob with the red dot on the battery
compartment cover.
Remove the cover by raising it by its lug.
Slide in two АА batteries so that the “+” and “-” match the polarity on the
inner side of the cover; rechargeable AA batteries may be used.
Close the cover of the battery compartment cover and turn the knob of the
cover 90° clockwise.
OPERATING THE RIFLESCOPE
Install the batteries according to the directions in the section entitled
“Battery Installation”.
Enter a dark environment.
Remove the objective lens cap by sliding it up on top of the objective lens
(2).
Activate the scope by turning the power switch to the “ON” position (3); the
indicator will turn green. A red indicator means that batteries are low and the
scope will be working with the IR illuminator turned on for 30 more minutes.
Warning: It is strongly recommended to test and operate the Sentinel GS in dark
conditions or at night time.
+
+
-
-
AA / 1.5 V
AA / 1.5 V
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pulsar Sentinel GS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pulsar Sentinel GS in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 5,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info