Manual Profoon PDX-2908 (page 1 of 2) (English)

692384

Zoom out

Zoom in

1/2

R/Flash function button, see para-

graph 4.6

Intercom button (only functional with

multiple handsets)

Redial button

Keypad

2 DISPLAY OVERVIEW

remains lit when within range from

the base; is off when out of range

from the base

ashes when you’ve received new

calls; disappears when the Caller-ID

memory of the concerned handset

has been fully checked

keep in mind that when using the

PDX-2928, each handset must be

checked separately

illuminates while reading the Cal-

ler-ID memory

illuminates when reading the last

dialled number memory

2. insert the supplied batteries into the bat-

tery compartment according to the mark-

ings.

3. Slide the battery cover back onto the

handset and place the handset on the

base/charger station.

4. Leave the handset continuously during

15 hours on the base station, to cradle/

charge the batteries properly.

4 CALLING

4.1Answering calls:

Press the key phone-on to accept a call

press the Call button again to enable

the speaker function

4.2 End the call:

press the key phone-off to end a call

To end a call, you can also place the

handset back on the base station or the

cradle/charger.

4.3 Dialing numbers:

Direct dialing:

Press the phone-on key and enter

the phone number through the key-

board; this number will be dialed

directly.

Block dialing:

Enter the phone number through the key-

board.

• press and hold the # button for at least 2

seconds to insert a dialing pause

• press the button to delete any incorrect

input

press the phone-on key; the number

will be dialed

dialing from the phonebook memory:

press the Phonebook button

and search for the desired

contact

press the phone-on key; the number

will be dialed

4.4 Speaker volume:

You can only adjust the speaker

volume during a call. You can choose

from 5 levels. Use the / but-

tons to increase or decrease the volume.

4.5 R/Flash:

During the call, shortly press the key

R to give a FLASH pulse.

The interruption time of the FLASH pulse is

adjustable; for this, see in paragraph 11.2.

4.6 Handset search function:

In case you’ve misplaced the handset, you

can easily nd it again as follows:

briey press the button at the bottom of the

base.

The handset will start ringing for 30 seconds

while the text ‘PAGING’ appears in the display.

The handset will stop ringing after 30 seconds

or after pressing a random button (handset)

or when pressing the button (base) again to

manually stop the signal earlier.

4.7 Voicemail notication: ( )(*)

In case the carrier left a Voicemail message for

you, a notication symbol ashes in the display

of the handset.

This symbol goes off as soon as you have

listened to this message. This symbol also

disappears after resetting the phone (see

paragraph 11.2).

*: This function is only available on the FSK

system and when this is supported by the

carrier.

4.8 To switch off the handset:

You can completely switch off the handset to

save battery power or in case you don’t want

to be disturbed:

to switch off:

pick up the handset from the base or charger

and press and hold the End button for 2 sec-

onds to completely switch off the handset

to switch on:

press and hold the End button for 2 seconds

to switch the handset on again

The handset also switches on when replac-

ing it onto the base or charger.

4.9 Call duration:

During the phone call, the elapsed call dura-

tion is displayed on the handset display.

10 seconds after disconnecting the call, the

call duration timer will disappear from the

display.

5 REDIALLING

Each handset memorizes the 10 last num-

bers you’ve dialed with the handset. You can

redial these numbers as follows:

press the Redial button,

search for the desired re-

cently dialed number and

press the phone-on

key; the number will be dialed

copy to the phonebook memory / deleting

press the Redial button and

search for the desired number

press the MENU button and select:

• SAVE NUMBER to save the selected

number

• EDIT ENTRY to edit the selected number

• DELETE to delete the selected number

• DELETE ALL to delete all last dialed

numbers

press the OK button and follow the on-screen

instructions

6 PHONEBOOK

6.1 Introduction:

The handset is provided with a phonebook

memory with a capacity of 50 contacts, each

with a phonenumber of up to 24 digits and a

name of up to 14 characters.

The phonebook memory in the handset is

connected to the function Caller Identica-

tion. When you are called by somebody,

whose name and number you have pro-

grammed in the memory, the name of this

person is also displayed beside the number

on the display of your handset.

6.2 Programming:

1. press the MENU button and then the OK

button

2. press the OK button and enter the name

using the keypad

3. press the OK button and use the keypad

to enter the phone number

press and hold the # button for 2 sec-

onds to insert a dialing pause

4. press the OK button

6.3 Dialing memory contacts:

press the honebook button

and search for the desired

contact

press the phone-on key; the number

will be dialed

6.4 Correcting:

1. press the MENU button

2. press the OK button and select EDIT

ENTRY

3. press the OK button and search for the

desired contact

4. press the OK button and press the

button to delete the name

5. use the keypad to enter the new name

and press the OK button

6. repeat this for the number and press the

OK button

USER MANUAL

1 OVERVIEW HANDSETBUTTONS

OK / MENU button

to open the menu and to conrm a

selection

Correction button, to delete the last

input;

: to open the Caller-ID memory

: to open the phonebook memory

/ : buttons: to scroll settings

and memories

Call button: to answer incoming calls

press the Call button again to ena-

ble the speaker function

End button: briey press to end a

call; press and hold to switch off the

handset

3 INSTALLATION

3.1 Base station:

Telephone connection:

insert the small plug of the telephone cable

into the TEL.LINE input at the rear of the

base (depress the plug until you hear a

click)

2. Plug the phone connector into the phone

socket.

Power supply:

1. insert the adaptor plug into the DC 6V

input at the bottom of the base

2. plug the adaptor into a 230 Volts wall

socket

3.2 Cradle/charger:

If your phone has been delivered with multi-

ple handsets, 2 batteries and a cradle/char-

ger with adapter will be included for every

handset. Plug the adapter of these chargers

in a 230 Volt mains socket.

3.3 Handset:

1. Open the battery compartment of the

handset, by sliding the battery cover

down.

ashes during an incoming call;

remains lit during a phone conver-

sation

illuminates when the speaker functi-

on is enabled

illuminates when the ringtone of the

handset is disabled

ashes when you’ve received a new

voicemail message

battery indication:

: battery is full

: battery still 2/3 full

: battery only 1/3 full, recharging

is recommended

: battery almost empty, the

handset may switch off at any mo-

ment

illuminates when using the /

buttons to show additional options or

memories in the display

illuminates when the number is too

long to be shown in the display,

press the # button to view the rest of

the number

PDX-2908

PDX-2928

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Profoon PDX-2908 in the language / languages: English as an attachment in your email.

The manual is 0,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Profoon PDX-2908

Profoon PDX-2908 User Manual - German - 2 pages

Profoon PDX-2908 User Manual - Dutch - 2 pages

Profoon PDX-2908 User Manual - French - 2 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Profoon PDX-2908 Manual

Product: