566861
1
Zoom out
Zoom in
Previous page
1/2
Next page
HALOGEN HAND LAMP BASIC
EN - 1
PLI-130
We thank you for the purchase of this Profile
product. Note: It is important that you read this
manual carefully before using the product And
be sure to save this manual for possible use
later.
Note
Check if building regulations apply to your area
whereby you must have the halogen hand
lamp installed by an accredited electrician. An
electrician can give you information about
correct wiring. Never install the fitting outside in
rainy weather.
SWITCH OFF THE POWER BEFORE YOU
INSTALL THE HALOGEN HAND LAMP.
Correct installation
With installation outside preferably choose a
place under a roof.
Connect the halogen hand lamp to a circuit
with wall switch.
The following distances must be respected
with installation:
Fig. 1 Fig. 2
Unscrew the stainless steel bolts on the side
to take the holder from the fitting.
Fix the holder to the wall with 2 screws. Do
not fix the holder to a highly flammable
surface. Leave a distance of at least 1 m
between the halogen hand lamp and the
object to be illuminated. (see fig. 2) Install
the halogen hand lamp at least 2.5 m above
the ground. (see fig.1)
Fig. 3
Fix the halogen hand lamp back on the
assembled holder.
Remove the cover of the cable connection.
Pull the power supply wires through the
opening with the rubber packing.
Connect the electric wiring according to
figures 3 and 4.
The halogen hand lamp must be connected
to mains voltage of 230V, max. fusing 16A.
Screw the cable connection cover tight
again.
Always respect the instructions on the
identification label of the connected power
cables.
Other uses than described above can cause
damage to the product and increase the risk
of short-circuit, fire, electric shocks, etc.
The product may not be adapted as a whole.
The safety instructions must be strictly
observed.
Safety instructions
The importer accepts no responsibility for
damage claims with respect to objects or
persons that result from incorrect use or non-
compliance with the safety instructions. Any
damage claims in such cases will be
declared null and void.
When replacing the halogen bulb the lamp
must first have cooled before the bulb is
replaced. Also disconnect the power supply.
Do not exceed the maximum wattage of
500W.
Always replace cracked or broken glass by
glass with the same properties as the original
glass.
Fig. 4
*
L = phase
*
= earthing
* N = neutral
wire
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Profile PLI-130 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Profile PLI-130 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Profile PLI-130

Profile PLI-130 User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info