566741

Profile PAC-324 Da Segno Manual

1
Zoom out
Zoom in
Previous page
1/2
Next page
DA SEGNO SET – Cordless doorbel set UK - 1
PAC-324
The cordless doorbell consists of 2 separate
components:
1. Push-button unit (transmitter)
2. Bell unit (receiver)
These items are completely independent of each
other and require no wiring.
When the push-button is pressed in, a signal is sent
to the bell, whereupon the bell is activated. Since it
has a range of up to 100 metres (in open spaces)
you can use the bell virtually anywhere in the house,
workshop, office, set it up in the garden or just carry
it with you.
Battery installation
Push-button unit
1. The push-button unit works using 1 x 3v
(CR2032) lithium battery (included).
2. The lithium battery is already installed.
Open the push-button and remove the
insulator strip.
3. Snap the rear side back into position, and
the push-button is ready for use.
To replace the battery:
1. Open up the push-button unit.
2. Remove the metal plate using a
screwdriver.
3. Place a 3v battery (CR2032) in the battery
compartment, making sure the positive
terminal (+) is uppermost.
Bell unit
1. Slide the rear cover open.
2. Place 2 C alkaline batteries into the battery
compartment.
3. The bell unit will produce a two-tone signal,
indicating that it is ready to read a digital
code (see channel selection).
4. Slide the cover firmly back into place; the
bell is now ready for use.
Installation
Push-button unit
Use the two small holes on
the rear of the push-button to
mark the position for
securing in place. Drill small
holes and mount the push-
button in position with
screws (self-tapping 3 x
16mm, included) or use the
double-sided adhesive tape
(included).
Important: If you secure the
push-button onto a metal
upper surface or PVC type of door (with metal), its
maximum range of transmission will be greatly
reduced.
Bell unit
This bell can be used as a portable device - or fixed
into position. On the reverse side, there are two
suspension slots, with which the bell can be hung
up using a screw, and can easily be taken down
again.
Choice of bell tone
The bell-tone selector button is inside the push-
button unit, below letter “S”. Press the button once
to hear the bell tone already set. Press again to
hear and select the next tune.
1) Westminster 2) Ding Dong
3) Ding-Dong-Ding 4) Tubular – 1
5) Orchestra 6) Tubular – 2
7) Trumpet 8) Dog Barking
Optionally: It is possible to instal an extra push-
button by your back door. By applying the procedure
given above, each push-button can produce a
different tune.
Channel selection
The unit is supplied with a pre-set radio frequency. If
by chance the bell should sound for no apparent
reason, it's possible that another device nearby is
using the same frequency. To get round this
problem, you can change the frequency of the push-
button and bell.
1. remove the cover behind the push-button.
2. To program or change: remove the
batteries from the bell unit for at least 30
seconds to prime the memory.
3. place the batteries back into position
within. Press the push-button after the two-
tone signal sound (with a second press of
the button if need be) to confirm the new
code. Do this within 1 minute. Don’t use
any other cordless products for the next 5
minutes.
4. Test for correct operation.
LED function
When the push-button is pressed, the gong will
sound. At the same time the blue LEDs will also
light up - ideal for the hard of hearing or when using
in a noisy environment. The light will show for
approx. 10 sec in order to attract the attention. If use
of LEDs is not required, they can be switched off by
means of the on/off button at the battery
compartment.
Mode function
1 x push: light and sound
2 x push: light
3 x push: sound
Volume selection
There is a volume-selector buttonat the pack of the
bell unit.
Trouble-shooting and tips
Problem:
Bell rings, but LEDs fail to light up
Possible cause:
The bell is out-of-range (max. 100m in open
spaces)
Push-button and bell are not set to the same
frequency
Possible solution:
Move the bell within range
Reprogram the channel (see channel selection)
Problem:
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Profile PAC-324 Da Segno at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Profile PAC-324 Da Segno in the language / languages: English as an attachment in your email.

The manual is 0,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Profile PAC-324 Da Segno

Profile PAC-324 Da Segno User Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info