722059

Pro-User Basic Plus Manual

6
Zoom out
Zoom in
Previous page
1/8
Next page
ASSEMBLY INSTRUCTIONS
1 & 1bis: Open the end-caps with a screwdriver, coin or key.
2: Loosen the setting bolts of the clamps and the bar.
3: Place the roof bar symmetrically onto the railings.
4: Equalize the roof bar clearances (approx. 700mm) to each other.
5: Use the setting bolt to pull the bar on the railing and tighten the screws on the
attachment clip. Then tighten all the setting screws.
6: Check the roof bar is tightly in place by pulling forwards and backwards. If
necessary, retighten the setting screws. Then replace the end-caps and lock them.
IMPORTANT INFORMATION
This roof bar is only suitable for cars with railings on the roof.
Please make sure you comply with the maximum permissible roof load for your
car. Fasten the load with suitable means (e.g. reliably secure using belts, lashes
or similar).
Strictly observe the assembly instructions to ensure the roof bar is assembled
properly and functions correctly!
To avoid damage to the roof of the car, two people are required to assemble and
remove the roof bar!
When assembling, ensure that the brackets do not protrude over the edge of the
car roof. Also, ensure that the clearance between the two bars should be at least
70cm, unless otherwise specified by the manufacturer of your car.
Ensure that the load is distributed evenly with the lowest point of gravity and do
not exceed the maximum roof load specified by the car manufacturer.
The permitted load comprises the deadweight of the roof bar of 4,7kg and the
actual load itself up to a maximum of 75kg (unless otherwise specified by the car
manufacturer).
The luggage shouldn’t protrude over the loading surface.
When transporting long loads, also attach the front end of the load to the car
bumper. Adjust your speed accordingly when driving.
Before each journey, after a short drive and at least every 300km, check that the
roof bar is tightly in place.
Be aware that the driving properties of the car will change when the roof bar is
loaded (the effect of winds from the side, driving around curves and braking
distances).
For reasons of safety and to save fuel costs, the roof bar should be dismantled
when not needed.
Notice that your vehicle's driving behaviour changes when the load carrier is
loaded (side wind sensitivity, curves and braking). Observe the recommended
speed!
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-User Basic Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-User Basic Plus in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info