558752

Prem-i-air EH1558 Manual

2
Zoom out
Zoom in
Previous page
1/12
Next page
Page 2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
INSTALLATION
For free-standing use: Attach the two castor-wheel brackets to the underneath
of the heater using the two M5 × 8 mm screws (one in each beacket). Attach the
castor-wheels to each bracket using the dome-nuts provided.
To wall-mount: Referring to the diagram opposite, draw two horizontal lines on
the wall 330 mm (13") apart, the lower line more than 50 mm (2") from the floor.
On the upper line, drill holes 189 mm (7½") from the centre line, using a 6 mm
(¼") masonry bit, and insert a wall plug.
On the lower line, drill holes 275 mm (11") from the centre line using a 6 mm (¼")
masonry bit, and insert a wall-plug.
Attach the two keyhole brackets to the upper holes in the back of the heater
using the four 10 mm self-tapping screws provided.
Fix the two L-shaped brackets to the underside of the heater the two M5 × 8 mm
screws. The screw goes through the ROUND hole in the bracket.
Insert two 25 mm (1”) screws into the upper holes and tighten until a gap of about
1.5 mm (
1
/
16
”) remains between the screw head and the wall.
Using the keyhole slots, hang the heater on the upper screws.
The L-shaped brackets will now line up with the lower holes in the wall. Attach to
the wall using the other two 25 mm (1") screws.
If the EH1558 is to be used in a bathroom, then it must be wall mounted,
and connected to the mains supply via a fused spur; and must be installed
by a qualified electrician in accordance with Section 701 of the 17
th
Edition
of the IEE Wiring Regulations.
PAT TESTING
When used in a workplace, this product must be safety-tested yearly by a
qualified electrician (PAT Tested) in order to comply with the Electricity at Work
Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
2 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Prem-i-air EH1558 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Prem-i-air EH1558 in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info