Do not use in bathrooms, or in wet locations.
Do not place the mains lead beneath a carpet or rug.
Do not use the appliance in locations where paint, petrol or other
flammable liquids are used or stored.
Always transport and store in an upright position.
Do not allow the appliance to fall over when there is water in the bucket.
PAT TESTING.
When used in an office environment, this product must be safety-tested
yearly by a qualified electrician (PAT Tested) in order to comply with the
Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at
least once every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the
wiring must be inspected at least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is
mandatory for new buildings).
OPERATION
Switch the appliance on at the mains socket.
Press the POWER button to switch the appliance on and off. The power
button illuminates green when the dehumidifier is switched on.
Use the MODE button to select the mode of operation. Low noise mode
is indicated by a 3-bladed fan, "turbo" mode is indicated by a 5-bladed
fan, and "laundry" mode by a picture of a garment. In Low Noise and
Turbo modes the appliance will reduce the humidity to the level set by the
"Humidity" control, whereas in Laundry mode it will operate continuously.
Press the HUMIDITY button to select the level of humidity required
(50% is probably the most comfortable setting). When the humidity is
reduced to the selected level, the dehumidification process will stop
(although the fan will continue to run). The two-digit display indicates the
current level of humidity. If the humidity level is already lower than the
selected level, this appliance cannot increase the humidity.
Page 3
