IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
INSTALLATION
For free-standing use: attach the feet to the underneath of
the heater using the four 12mm (½") screws.
To wall-mount: Firstly, remove the lower bracket from the
back of the heater, turn it upside down and replace it, so that
the tag protrudes below the heater.
Referring to the diagram opposite, draw two horizontal lines
on the wall 431mm (17") apart, the lower line more than
50mm (2") from the floor.
On the upper line, drill holes 110mm (4½") from the centre
line, using a 6mm (¼") masonry bit, and insert a wall plug.
Insert a screw into the hole and almost fully tighten.
On the lower line, drill a hole on the centre line using a 6mm
(¼") masonry bit, and insert a wall-plug.
Hang the heater on the two top brackets using the keyhole
slots on the back.
The lower bracket should now line up with the lower hole.
Insert a screw into the hole through the bracket, and fully
tighten.
Page 2
