672611
13
Zoom out
Zoom in
Previous page
1/17
Next page
POWXQG7555 EN
Copyright © 2017 VARO P a g e | 13 www.varo.com
Be sure to carefully balance blade after sharpening. The blade can be tested for balance by
balancing it on a round shaft screwdriver. Remove metal from the heavy side until it balances
evenly.
Before reassembling the blade and the blade adapter to the unit, lubricate the engine
crankshaft and the inner surface of the blade adapter with light oil. Install the blade adapter on
the crankshaft with the "star" away from the engine. Refer to figure 15. Place the blade with
the part number facing away from the adapter. Align the washer over the blade and insert the
hex bolt. Tighten the hex bolt to the torque listed below:
9.3.3 Blade mounting torque
Centre Bolt 40 Nm-50 Nm, to insure safe operation of your unit. ALL nuts and bolts must be
checked periodically for correct tightness.
After prolonged use, especially in sandy soil conditions, the blade will become worn and lose
some of the original shape. Cutting efficiently will be reduced and the blade should be
replaced. Replace with an approved factory replacement blade only. Possible damage
resulting from blade unbalance condition is not the responsibility of the manufacturer.
When you change the blade you must use the original type marked on the blade.
10 STORAGE INSTRUCTIONS (OFF SEASON)
The following steps should be taken to prepare lawn mower for storage.
1. Empty the tank after the last mowing of the season.
Empty the petrol tank with a suction pump.
Caution! Do not drain the petrol in closed rooms, in close proximity of open
fire, etc. Do not smoke! Petrol fumes can cause explosion or fire.
Start the engine and let it run until it has used up all remaining petrol and stalls.
Remove the spark plug. Use an oilcan to fill approx. 20 ml oil into the combustion
chamber. Operate the starter to evenly distribute the oil in the combustion chamber.
Replace the spark plug.
2. Clean and grease the lawnmower carefully as described above under “Lubrication”.
3. Slightly grease the cutter to avoid corrosion.
4. Store the lawnmower in a dry, clean and frost-protected place, out of reach of
unauthorized persons.
Caution! The engine must have completely cooled down before storing the
lawnmower.
NOTE:
When storing any type of power equipment in an unventilated or material storage shed,
care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the
equipment, especially cables and all moving parts.
Be careful not to bend or kink cables.
If the starter rope becomes disconnected from rope guide on handle, disconnect and
ground the spark plug wire, Depress the blade control handle and pull the starter rope out
from engine slowly. Slip the starter rope into the rope guide bolt on handle.
11 TRANSPORT
Turn the engine off. Ensure not to bend or damage the cutter when pushing the lawnmower
over obstacles.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXQG7555 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXQG7555 in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXQG7555

Powerplus POWXQG7555 User Manual - German - 19 pages

Powerplus POWXQG7555 User Manual - Dutch - 18 pages

Powerplus POWXQG7555 User Manual - French - 18 pages

Powerplus POWXQG7555 Additional guide - All languages - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info