753354
10
Zoom out
Zoom in
Previous page
1/12
Next page
POWXG90501 EN
Copyright © 2021 VARO P a g e | 10 www.varo.com
11.1 Cleaning of inlet filter
Clean the water inlet filter regularly Flush with water to remove dirt and debris.
CAUTION: Failure to fit the filter will invalidate the warranty
11.2 Cleaning of air vents
The machine should be kept clean so as to let cooling air pass freely through the machine
vents.
11.3 Greasing of couplings
To ensure an easy connection and that o-rings do not dry up; the couplings should be greased
regularly.
12 STORAGE
The machine should be stored in a frost-free room!
Pump, hose and accessories should always be emptied of water prior to storing as follows:
1. Stop the machine (turn the start/stop switch “O” and detach water hose and nozzle.
2. Restart the machine and activate the trigger of the trigger gun. Let the machine run until
no more water runs through the trigger gun
3. Stop the machine, unplug and wind up hose and cable.
4. Place trigger gun, lance, nozzles and other accessories in the holders of the machine.
The hook can be used for storage of the hose and cord
Should the machine by mistake be frozen, it will be necessary to check it for damage.
WARNING: Never start up a frozen machine. Frost damages are not covered
by the guarantee!
13 TROUBLE SHOOTING
SYMPTOM
CAUSE
RECOMMENDED ACTION
Machine refuses to
start
Machine not
plugged in
Plug in machine.
Defective socket
Try another socket.
Defective extension
cable
Try without the extension cable.
Fluctuating pressure
Pump is sucking air
Check that hoses and connections are
airtight.
Valves dirty, worn
out or stuck
Contact your nearest service centre
Water supply not
sufficient
Increase water pressure, check for blockage
of garden hose and/or change to bigger hose.
Pump seals worn
Contact your nearest service centre
Machine stops
Incorrect mains
voltage
Check that the mains voltage corresponds to
specification on the name plate
Thermal sensor
activated
Leave the machine for 5 minutes to cool down
Nozzle partially
blocked
Clean the nozzle with a needle and by
spraying water backwards through the nozzle
Amperage increase
Try without the extension cable.
Machine pulsating
Air in inlet
Allow machine to run with open trigger until
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXG90501 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXG90501 in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXG90501

Powerplus POWXG90501 User Manual - German - 14 pages

Powerplus POWXG90501 User Manual - Dutch - 13 pages

Powerplus POWXG90501 User Manual - French - 13 pages

Powerplus POWXG90501 Additional guide - All languages - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info