517143
20
Zoom out
Zoom in
Previous page
1/22
Next page
POWXG1018 EN
Copyright © 2015 VARO P a g e | 20 www.varo.com
14 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
99
Acoustic power level LwA
115
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
Max 11.8 m/s²
K = 1,5 m/s²
15 STORING A CHAIN SAW
Caution: never store a chain saw for longer than 30 days without performing the following
procedures. Storing a chain saw for longer than 30 days requires storage maintenance.
Unless the storage instructions are followed, fuel remaining in the carburetor will evaporate,
leaving gum-like deposits. This could lead to difficult starting and result in costly repairs.
Remove the fuel tank cap slowly to release any pressure in tank. Carefully drain the fuel
tank.
Start the engine and let it run until the unit stops to remove fuel from carburetor.
Allow the engine to cool (approx. 5 minutes).
Using a spark plug wrench, remove the spark plug.
Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace spark plug. (Fig.19)
Note: store the unit in a dry place and away from possible sources of
ignition such as a furnace, gas hot water heater, gas dryer, etc.
Removing a unit from storage
Remove spark plug.
Pull starter rope briskly to clear excess oil from combustion chamber.
Clean and gap spark plug or install a new spark plug with proper gap.
Prepare unit for operation.
Fill fuel tank with proper fuel / oil mixture. See fuel and lubrication section
16 TROUBLE SHOOTING
PROBLEM
PROBABLE CAUSE
CORRECTIVE ACTION
Unit won’t
start or
starts but
will not run.
Incorrect starting procedures.
Incorrect carburetor mixture
adjustment setting.
Fouled spark plug.
Empty fuel tank.
Primer bulb was not pressed
enough.
Follow instructions in the user manual.
Have carburetor adjusted by an
authorized service center.
Clean/gap or replace plug.
Fill fuel tank with properly mixed fuel.
Unit starts,
but engine
has low
power.
Fuel filter is plugged.
Incorrect lever position.
Dirty spark arrestor screen.
Dirty air filter.
Incorrect carburetor mixture
adjustment setting service dealer.
Replace the fuel filter.
Move to run position.
Replace spark arrestor screen.
Remove, clean and reinstall filter.
Have carburetor adjusted by an
authorized service center.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXG1018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXG1018 in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXG1018

Powerplus POWXG1018 User Manual - German - 28 pages

Powerplus POWXG1018 User Manual - Dutch - 28 pages

Powerplus POWXG1018 User Manual - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info