POWX00420 EN
Copyright © 2022 VARO P a g e | 5 www.varo.com
▪ Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
▪ Do not open the battery yourself. There is danger of a short circuit.
▪ Protect the battery against heat, e.g., including against continuous sun irradiation and fire.
There is a danger of explosion.
▪ Do not short-circuit the battery. There is a danger of explosion.
▪ In case of damage and improper use of the battery, vapours may be emitted. In case of
complaints, provide for fresh air and consult a physician. The vapours can irritate the
respiratory system.
7 OPERATION
7.1 Driver bits (Fig.1)
▪ Different driver bits can be used with this product depending on the screw heads being
worked with. Use the driver bits which are 25 mm long supplied.
▪ To install the bits, insert the desired bit into the bit holder (1) until it is properly fixed.
▪ To remove the bits, pull it out carefully from the bit holder (1).
7.2 Charging procedure (Fig.2)
The battery of this product is integrated in this tool and cannot be removed.
The battery has been shipped in a low charge condition. Charge it fully before first use. The
screwdriver is supplied with a USB charging cable. The small connector is a type USB C and
the large connector is a standard type USB A connector. This means the screwdriver can be
charged via any USB A output socket, either from a USB adapter (smartphone) or power
bank, laptop etc.
▪ Plug the USB C connector into the charging socket (3).
▪ Connect the USB A connector to any USB A output socket or USB adapter (not included).
▪ Connect the USB adapter (not included) to the mains power supply.
▪ The charging indicator (2) shows the charging status.
▪ When the charging indicating LED light flashes, this means the screwdriver is now being
charged. Normally it will take 3-5 hour to fully charge the battery.
▪ When all 3 green LED lights are lit, the battery is fully charged.
▪ After charging is finished, disconnect the USB cable from the screwdriver.
During the charging procedure, the handle of the machine warms up. This
is normal.
When the charging is finished, disconnect the battery charger from the
socket.
Do not use the machine during the charging procedure.
7.3 Forward / reverse rotation control (Fig. 3)
Change the rotational direction from forward to reverse by pressing the forward (F) / reverse
(R) rotation control button (4).
WARNING! Only change the rotational direction when the product is
switched off and has come to a complete stop! Always ensure that the
forward / reverse rotation control is adjusted to the correct position
depending on the intended operation!
