POWX00410 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
7.4 On/Off trigger
Use the On/Off trigger to start the machine and keep holding it for continuous operation.
To switch the machine off, release the On/Off trigger
7.5 Changing the angle of the tool
The tool’s angle can be changed by turning the handle up or down.
To change the tool’s angle, stop the machine.
Do not change the angle of the tool, when it is operating!
7.6 Working spot light
Turn the working light switch to the ON position, the working light will light up.
Turn the working light switch to the OFF position, the working light goes out.
7.7 Screw insertion
Insert the screw-bit into the slot in the head of the screw. Hold the screw bit perpendicular to
the head of the screw, otherwise the screw or the screw head may be damaged. Press the
screw bit against the screw with a constant pressure while driving in the screw by pulling or
pushing the ON/OFF switch up or down
When the screw is completely screwed in, hold the machine firmly and
release the On/Off trigger, otherwise the screw or the screw head may be
damaged. If the On/Off trigger is not released immediately a high torque
could also damage the screw-bit or the screwdriver.
7.8 Screw removal
Insert the screw-bit into the slot in the head of the screw. Hold the screw-bit perpendicular to
the head of the screw, otherwise the screw or the screw head may be damaged. Press the
screw bit against the screw with a constant pressure while removing the screw pulling or
pushing the ON/OFF switch up or down
8 CLEANING AND MAINTENANCE
8.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
▪ Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
8.2 Maintenance
Attention! Always switch off the screwdriver and lock the switch in the OFF position before
carrying out any work on the machine.