POWP6010 EN
Copyright © 2018 VARO NV P a g e | 8 www.varo.com
▪ Set the tool on a flat surface with the rear base flat with the surface, adjust the “L” guide so
that the distance between the bottom surface of the “L” guide and the flat surface equals
to the desired rebating depth, tighten the fixing screw of “L” guide.
▪ Set the cutting depth adjustment knob to a suitable depth.
▪ Carry out the planning with the flat surface of “T” guide kept tight against the edge of
workpiece. Repeat cutting until the bottom surface of “L” guide is level with the surface of
workpiece.
9 TROUBLE SHOOTING
If any of the following events occur during normal operation, the power supply should be shut
off at once and tool thoroughly inspected by a qualified person and repaired if necessary:
▪ The rotating parts get stuck or speed drops abnormally low.
▪ The tool shakes abnormally accompanied by some unusual noise.
▪ The motor housing gets abnormal hot.
▪ Heavy sparks occur around the motor area.
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
10.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2 Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular basis.
▪ In case of wear, replace both carbon brushes at the same time.
▪ Mount the carbon brush holders.
▪ After mounting new carbon brushes, let the machine run at no load for 15 minutes.
Use only the correct type of carbon brushes.
10.3 Connecting cable and mains plug
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
