POWP3060 EN
Copyright © 2018 VARO P a g e | 6 www.varo.com
▪ Warning! The use of any accessory or attachment, other than recommended in this
instruction manual, may present a risk of personal injury.
▪ Have your tool repaired by a qualified person. This electrical tool is in accordance with the
relevant safety requirements. Repairs should only be carried out by qualified persons
using original spare parts, otherwise this may result in considerable danger to the user.
7 APPLICATION
7.1 Switching On/Off (Fig. 2)
Plug the cord set into power socket.
▪ Switching on: Press the ON/OFF switch trigger (1).
▪ Switching off: Release ON/OFF switch trigger (1).
7.2 How to use the demolition hammer
1. After placing the tip of the tool on concrete surface, switch ON.
2. By utilizing the weight of the machine and by firmly holding the demolition hammer with
both hands, one can effectively control the subsequent recoil motion.
3. Proceed at a moderate work-rate, the use of too much force will impair efficiency.
CAUTION! After long time of use, the cylinder case becomes hot.
Therefore, be careful not to burn your hands.
WARNING! Don’t apply big pressure to the machine. The hammer
mechanism is activated by applying a slight pressure on the tool when the
chisel bit is in contact with the work-piece.
8 CHANGING TOOLS
Unplug the tool from the power supply, only use drill spindles compatible with the tool.
8.1 Mounting chisel
CAUTION: Be sure to switch power OFF and disconnect the plug to avoid
serious trouble.
8.1.1 Inserting the tool (Fig. 3)
▪ Clean the tool before fitting it and apply a thin coating of grease to the tool shaft.
▪ Pull out the locking bolt (4) as far as possible, turn it through 180° and release it.
▪ Insert the tool into the tool mounting (5) and push it in as far as possible.
▪ Pull out the locking bolt (4) again, turn it through 180° in the opposite direction and release
it.
▪ Check the lock by pulling the tool.
8.2 Dismantling
Proceed in reverse order to mounting
WARNING Accessories can be hot after use. Don’t touch the tip of
accessory by hand! Please always use protective gloves to remove the
accessory.