POWP3010 EN
Copyright © 2018 VARO P a g e | 6 www.varo.com
7.5 Selecting the operation mode (Fig. 4)
The rotary hammer drill can be used in the following operation modes.
▪ Rotary drilling
For screwdriver and for drilling into steel, wood and plastics.
▪ Hammer drilling
Simultaneous rotating and impacting for concrete and masonry drilling
▪ Hammer only
for light chipping, chiselling and demolition applications .
▪ Bit rotation
Non-working position used only to rotate a flat chisel into the desire position.
Select the required operating mode by depressing the safety button and rotating the mode
selector switch until it points to the symbol of the required mode.
Release the safety button and check that the mode selector switch is locked place.
Do not select the operating mode when the tool is running.
For screw driving, refer to section: “Instructions for use”.
Always wait until the machine has come to a complete standstill before
changing the drilling , hammer/drilling function.
Do not use the chuck with SDS connector in combination with the
hammer/hammer drill function!
8 OPERATION
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Resharpen or replace blunt drill bits.
8.1 Switch on/off
Plug the cord set into power socket.
To start the tool squeeze the on/off switch (7).
To stop the tool , release the on/off switch.
If you press the lock-on button (8) while the on/off switch is depressed, the on/off switch is
kept in the operating position.
To release the on/off switch (7) again, press it briefly to and turn the tool off.
The harder you squeeze the on/off switch (7) the faster the tool will operate.
Use lower speeds for starting.
