POWE10030 EN
Copyright © 2018 VARO P a g e | 5 www.varo.com
Always use ear-protection, when machine is in use!
Recommended nominal operating-time: approx. 20 minutes under
permanent load.
Rest after permanent operation: approx. 5-10 minutes.
7 OPERATION
WARNING: Prior to assembly and adjustment always pull out the power
plug from the mains socket.
7.1 Changing drill or screwdriver bit
This drill has a keyless chuck with lock (1) to prevent the bit or drill from loosening.
▪ Hold ring B of the drill chuck tight with one hand.
▪ Turn upper ring A anticlockwise with the other hand until the drill chuck opening is large
enough to accept the tool.
▪ Insert the drill or the screwdriver bit into the drill chuck.
▪ Turn ring B clockwise until the tool is snapped into lock place and clamped tightly.
▪ Remove the tool in the opposite way.
7.2 Switching on/off (Fig. 1)
▪ Connect the plug to the power supply. The power-on indicator (9) is illumed until the tool
disconnect from the power mains.
▪ To start the tool by squeezing the ON/OFF switch (4).
▪ Release the ON/OFF switch to stop the tool.
▪ If you press the lock-on button (6) while the ON/OFF switch is depressed, the ON/OFF
switch is kept in the operating position.
▪ To release the ON/OFF switch (4) and turn the tool off.
7.3 Forward/reverse lever (Fig. 2)
▪ The forward/reverse lever (3) is to determine the rotation direction of the chuck.
▪ To select forward rotation, release the ON/OFF switch (4) and push the forward/reverse
lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side
of the tool.
NOTE: When changing the position of the lever, be sure the ON/OFF switch
is released and the motor is stationary.