POWDPG75610 EN
Copyright © 2022 VARO P a g e | 11 www.varo.com
9.2 Grass box assembly (Fig. A & E)
▪ The grass box (3) comes in 3 separate parts and needs to be assembled.
▪ Put the lower part (a) on a flat surface and fit the top part (b) in place.
▪ Make sure all connecting parts snap firmly together.
▪ Fit the handle (c) to the top part in the same way.
9.3 Installing the grass box. (Fig. A & B)
▪ Remove key (2) and battery pack (12).
▪ Lift the rear discharge door (18).
▪ Lift the grass box by its handle and place under the rear discharge door so that the
hooks on the grass box are seated onto the slots on the mower housing.
▪ Release the rear discharge door (18).
▪ Reinstall key and battery pack when you are ready to mow.
10 OPERATION
10.1 Starting/stopping the mower (Fig. A & B)
▪ Raise the battery cover (7).
▪ Install battery pack (12).
▪ Insert the key (2) into the key hole.
▪ Lower the battery cover (7).
▪ Press and hold the start button (1). Pull the brake lever (11) toward the handle and
release the button to start the mower.
▪ To stop the mower, release the brake lever (11).
10.2 Setting blade height (Fig. A & F)
When shipped, the wheels on the mower are set to a low-cutting position. Before using the
mower for the first time, raise the cutting position to the height best suited for your lawn.
▪ Remove key (2) and battery pack (12).
▪ To raise the blade height, grasp the height adjustment lever (6) and move it toward the
back of the mower.
▪ To lower the blade height, grasp the height adjustment lever (6) and move it toward the
front of the mower.
▪ Reinstall key (2) and battery pack (12) when you are ready to mow.
10.3 Grass box warning system (Fig. A & E)
▪ There is a warning piece (d) in the grass box which will indicate the grass volume.
▪ If the flap (d) is open it means that there is still space for grass collection.
▪ If the flap (d) is closed it means that there is no space for grass collection.
11 CLEANING AND MAINTENANCE
11.1 Cleaning
▪ Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
▪ We recommend that you clean the device immediately each time you have finished using
it.
▪ Clean the equipment regularly with a moist cloth and some soft soap.
▪ Do not use cleaning agents or solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the device.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
