480975
5
Zoom out
Zoom in
Previous page
1/8
Next page
POW222 EN
Copyright © 2015 VARO P a g e | 5 www.varo.com
Press the spindle lock button(12) and loosen the flange nut using the pin spanner.
Remove the diamond cutting discs and the spacer rings.
Place one diamond cutting disc onto the motor flange.
Slide space rings (as required) followed by the remaining diamond cutting disc on the
spindle.
Press the spindle lock button(12) and screw the flange nut onto the spindle using the pin
spanner.
Rotate the depth stop upwards, and replace the depth stop
Put screws back in place using the hex key. (Caution! Do not forget the washer and lock
washers replace the depth stop fixing screw)
Caution! Always replace diamond cutting discs in pairs. To loosen /
tighten discs: Press spindle lock button, turn disc by hand until it locks,
then loosen / tighten with pin spanner.
7 DEPTH ADJUSTMENT (FIG. 5)
Loosen the fixing screw for depth stop (4)and set the require depth.
Re-tighten the fixing screw for depth stop select a chase depth approximately 3mm deeper
that the actual required depth to compensate for unevenness in the wall surface.
8 TURNING THE MACHINE ON/OFF (FIG. 6)
Press the safety switch (10) and pull the trigger(3) ,the machine is on.
Release the trigger ,the machine is off.
The machine fitted with a soft start mechanism
The machine has an overload protection device. In case of overload, it will shut down
automatically. Release the trigger and remove the machine from the work-piece. Allow to
cool for a few minutes, then restart and run the machine at no-load for approximately one
minute to cool the machine down faster.
9 ADJUSTING THE CHASE WIDTH (FIG. 7 - 9)
The machine is supplied with two spacer rings (10mm and 15 mm). The chase width is
adjusted by varying the amount of spacer rings between the diamond cutting discs. Mind
the width of the diamond cutting discs. The maximum chase width is approximately 29mm.
Make sure at least 5mm thread remains to tighten the outer spanner ring.
10 DUST EXTRACTION (FIG. 10)
The wall slotter is equipped with a dust extractor socket. You can connect your vacuum
cleaner to the socket at the rear of the wall slotter. If you require a special adapter, please
contact the manufacturer of your vacuum cleaner.
11 OPERATION (FIG. 11)
Mark the line of cut before starting work, hold the machine tightly with both
hands.
Set the chase depth, press the front edge of the depth stop, firmly against the wall. Switch
the machine on and gently lower the machine towards the wall until the rotating diamond
cutting discs plunge into the wall ,Hold the machine tightly with both hands.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POW222 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POW222 in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POW222

Powerplus POW222 User Manual - German - 9 pages

Powerplus POW222 User Manual - Dutch - 9 pages

Powerplus POW222 User Manual - French - 9 pages

Powerplus POW222 Additional guide - All languages - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info