506162
6
Zoom out
Zoom in
Previous page
1/12
Next page
6 - 12
PRODUCT FEATURES
General
Integrated high power amplifier
High efficient low-mid woofer
Line and mic input with Bass and Treble
Controls
Line output allows daisy chaining of additional
speakers
High power dynamic horn driver
Wide dispersion directivity horn
Stand mounting with 35mm pole socket
ABS scratch-resistant housing
Compact speaker system for easy transport
Recommended for
Bars
Restaurants
Small theatre
Karaoke
Fitness
Conference rooms
Small halls
Stage monitoring
INPUT PANEL
1. Balanced input connector MIC (PDA-8A: 6.3mm Jack or PDA-10A XLR-6.3mm Jack)
2. Volume control for MIC
3. Line input for audio input source e.g. mixer, CD player, etc
4. Balanced XLR line input
5. Volume control for Line Input
6. Tone control Bass and Treble
7. Output connector (line out). For connection to a second active speaker box.
8. Clip indication. These LED will light up when amplifier are on max power. It can occur that these LED
will lit up now and then, this is not a problem. But if it lights up continually you need to adjust the volume
down, otherwise permanent damage to equipment might occur
9. Power Indication. This clear green indicator will light when the amplifier is turned on.
10. On/Off Switch: For switching the speaker on and off. Always adjust the volume down to its minimum
before switching this speaker on.
11. Mains Power Connector / Fuse. This main fuse secures the speaker against defects. Replace this only
with a fuse of same type and value.
TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work
correctly for the suspected problem speaker. If the “normally correct speaker” is experiencing the same
difficulties or problems as the suspected problem speaker, use the information below to isolate the problem.
No output
Possible cause / Action:
Speaker cables, Reseat all connectors, Inspect cable for damage, Inspect wire or connector for stray strand
that may short
Intermittent
Possible cause / Action:
Poor connections. While it is possible for a faulty speaker to exhibit intermittent output, it’s more likely that an
output cable/connector is the problem. Reseat all connectors
Constant noise, buzzing and/or humming
Possible cause / Action:
Any constant noise originates in the amplifier, mixer, signal processing, source device in the signal devices,
or line-level wiring. Check and correct system grounding as required. Chain check for noisy sources or
electronic components. Check wiring for shielding.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit.
This would also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by
inappropriate use or disrespect of the warnings contained in this manual. Tronios cannot be held responsible for
personal injuries caused by a disrespect of the safety recommendations and warnings. This is also applicable to all
damages in whatever form.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Power Dynamics PDA 10A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Power Dynamics PDA 10A in the language / languages: English, German, Dutch, Spanish as an attachment in your email.

The manual is 0,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info