648854
7
Zoom out
Zoom in
Previous page
1/8
Next page
E
E
N
N
G
G
L
L
I
I
S
S
H
H
VL FOREVER 980 / FOCUS STEAM / PRO - 970 ANTI-SHINE
30
NOTE:
• Both (5) and (11) lights go on and off during
operation; this is quite normal and means
that the electric resistance is operating to
maintain constant the pressure in the boil-
er.
If no steam is released from the iron, check
that the steam pressure light (5) is off.
C
C
L
L
E
E
A
A
N
N
I
I
N
N
G
G
T
T
H
H
E
E
W
W
A
A
T
T
E
E
R
R
F
F
I
I
L
L
T
T
E
E
R
R
If the water filter (4) becomes dirty, proceed
as described below:
Remove the tank lid (1).
Remove the water filter (4) (fig.6) from its
place and clean it under running water.
• Put the filter (4) back in its place and close
the tank lid.
F
F
I
I
L
L
L
L
I
I
N
N
G
G
T
T
H
H
E
E
T
T
A
A
N
N
K
K
Thanks to the self-filling function, there is no
longer any need to stop and wait while the
boiler fills up again.
When the water inside the boiler reaches its
low level, the thermostat will automatically
activate a pump that will fill the boiler from the
tank.
It is necessary to refill the feeder tank with
water before it becomes empty.
If, on pressing the steam request button no
steam comes out and you also hear the
pump noise increase, it means that there is
no more water in the tank.
To keep on working, simply restore the water
level in the self-refilling tank as described in
the “Preparation for use” paragraph.
C
C
A
A
R
R
E
E
O
O
F
F
Y
Y
O
O
U
U
R
R
V
V
A
A
P
P
O
O
R
R
E
E
L
L
L
L
A
A
Before attempting any maintenance
operation, always disconnect the ap-
pliance from the mains.
To clean the body of the appliance, simply
use a moist cloth. Do not use solvents or
detergents which may harm the body mate-
rial.
C
C
L
L
E
E
A
A
N
N
I
I
N
N
G
G
T
T
H
H
E
E
B
B
O
O
I
I
L
L
E
E
R
R
Disconnect the appliance and let it cool
down for at least 2 hours.
Empty the water tank to prevent leakage.
Turn the appliance upside-down and use
the hexagon wrench (13) to unscrew the
boiler cap (12) on the bottom of the ap-
pliance (fig.7).
Use the funnel (14) to pour 1/4 litre of cold
water into the boiler.
CAUTION: do not pour more than the
specified amount of water into the boi-
ler. Pour water slowly, being careful not
to let it overflow, as this could damage
the appliance (fig.8).
Rinse out the boiler and pour the water
away into the sink or into a container for
collecting dirty water.
If the water is very dirty, repeat the opera-
tion until it is clean.
Put the cap back on the boiler, checking
that the seal is present and that the cap is
screwed on properly.
Fill the water tank again and put the cap
on.
Turn the appliance on again.
Before ironing, release steam into the sink
or another container and check that the
steam is clean. This should take a few se-
conds.
Resume ironing normally.
To maintain optimum performance, clean
the boiler every 10/20 uses depending on
the amount of limestone in the water.
VL FOREVER 980-970 M0S09407 1Q08:FEV 1000-950.qxd 15/09/2010 10.45 Pagina 30
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Polti Vaporella Forever 970 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Polti Vaporella Forever 970 in the language / languages: English as an attachment in your email.

The manual is 2,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti Vaporella Forever 970

Polti Vaporella Forever 970 User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info