649052
18
Zoom out
Zoom in
Previous page
1/20
Next page
ENGLISH
| 32|
Should the problems persist, contact an Authorised Polti Service Centre (see www.polti.com for the up-to-date list) or
Customer Services.
ALARMS CAUSE SOLUTION
Boiler fault Turn the appliance off for a few minutes and
then start it again. Should the problem occur
again, contact an Authorised Service Centre.
The boiler does
not reach the
desired
temperature.
Turn the appliance off for a few minutes and
then start it again. Should the problem occur
again, contact an Authorised Service Centre.
The pump
continues to take
in water.
Turn the appliance off for a few minutes and
then start it again. Should the problem occur
again, contact an Authorised Service Centre.
- “Out of water” indicator light flashing
- Prolonged beeping sound
- LED programs flashing
- 1st steam adjustment LED flashing
- “Out of water” indicator light flashing
- Prolonged beeping sound
- LED programs flashing
- 2nd steam adjustment LED flashing
- “Out of water” indicator light flashing
- Prolonged beeping sound
- LED programs flashing
- 3rd steam adjustment LED flashing
PROBLEM CAUSE SOLUTION
The appliance is pressurised but
releases little steam
The steam is set to the minimum
level
Press the steam adjustment button (+) to
increase the steam being dispensed
There is a bad smell when turning on
suction
Dirt collector is dirty or too wet Clean the dirt collector as described in
Chapter 13 or simply dry it out If the smell
persists, carry out a full clean as described in
Chapters 13, 14, and 17.
Steam is dispensed mixed with drops
of water
The steam hose and/or the
telescopic tube are cold
Direct the steam jet onto a cloth to heat up
the tubes
The holder with cloth for steam
cleaning does not lock onto the brush
The brush is in position B or C Set the universal brush to position A
Accessories are difficult to assemble The seals produce friction Lubricate the gasket with silicone grease or
Vaseline, or alternatively with a small amount
of vegetable oil.
The filling pump of the
boiler continues to operate
There is air in the boiler
circuit.
Turn off the appliance and leave it
to cool, then repeat the
operations described in Chapter 1
After vacuuming, traces of liquid
remain on the flooring
Liquid remains inside the tubes
Floor not yet dry
Suck in air for a few seconds to allow the
transfer of the liquid to the tank
Repeat the vacuuming
Manuale UNICO MCV50-MCV70 VERSIONE 16-09-14_vers7:UNICO 22/09/2014 16.19 Pagina 32
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Polti UNICO MCV50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Polti UNICO MCV50 in the language / languages: English as an attachment in your email.

The manual is 2,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti UNICO MCV50

Polti UNICO MCV50 User Manual - German - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info