76347
3
Zoom out
Zoom in
Previous page
1/3
Next page
F
F
U
U
N
N
C
C
T
T
I
I
O
O
N
N
I
I
N
N
G
G
Unroll the supply cable (11) till reaching the yellow sign on the
cable itself, by pulling it as shown in fig 1. DO NOT under any
circumstances unroll beyond the red sign.
Insert the suction opening on hose (D) into connection (5) (fig.
2).
• Plug into a suitable power outlet.
Press the ON/OFF switch (7). The appliance will start opera-
ting. The ON/OFF switch (7) can also be operated by touching
it with your foot, so you do not have to bend.
It is possible to regulate suction power through the slide cur-
sor (9). Moving the cursor forward, the power increases,
moving the cursor backwards the power decreases. We
recommend minimum power for curtains, medium-low power
for sofas, armchairs and cushions, medium-high for carpets
and high for floors and hard surfaces (ceramics, marble, etc.).
Thanks to the manual suction regulator (C2), the suctioning
power can be changed according to the cleaning task, and it
allows you to stop promptly in case of accidental suctioning
(e.g. of curtains). We recommend an open regulator on cur-
tains, carpets, sofas and so on. Move the regulator forward till
uncovering the hole on the hose. To suction again at maximum
power, move the regulator backwards till it covers the hole.
To stop vacuuming, press again the ON/OFF switch (7).
E
E
M
M
P
P
T
T
Y
Y
I
I
N
N
G
G
A
A
N
N
D
D
C
C
L
L
E
E
A
A
N
N
I
I
N
N
G
G
T
T
H
H
E
E
D
D
U
U
S
S
T
T
C
C
O
O
N
N
T
T
A
A
I
I
N
N
E
E
R
R
Switch off the appliance (7). Disconnect the supply cable (11)
from the mains.
Disconnect the flex hose (D) from the appliance, by pressing
button (C1) and pulling out the hose.
Press the button to detach the dust container (4) on the top lid
(3) (fig.3).
• Remove the dust container (1), holding it by the handle (2).
Press the button (2a) on the handle (2) to open the container
and get rid of the collected dirt (fig.4).
ATTENTION: when pressing the button (2a), the underside of
the container opens automatically, so we recommend to empty
the container over a rubbish bin.
Remove the filter assembly (15) and let any traces of dirt esca-
pe (fig.5).
• We recommend to clean the container after each use.
ATTENTION: DO NOT use the appliance without dust contai-
ner (1) and its filter.
Put the dust container back in place.
U
U
S
S
I
I
N
N
G
G
A
A
C
C
C
C
E
E
S
S
S
S
O
O
R
R
I
I
E
E
S
S
Accessories may be connected directly to the hose (D) or to the
telescopic tube (A)
Using the telescopic tube (A)
The tube is about 50 cm long when closed, about 80 cm when
extended to its greatest length. To increase or decrease length,
press the button (A1) and extend or reduce length as desired.
Using the universal brush (B)
Connect the brush to the telescopic tube. If you move the selec-
tor on the brush (B1) and press with a foot, you can change the
suctioning surface without bending down. The position with bri-
stles extended is recommended for all non-carpeted floors. The
position without bristles is recommended for carpets.
Using the small nozzle (E)
The small nozzle is recommended for cleaning upholstery surfa-
ces such as the joints of sofas, armchairs, mattresses, car uphol-
stery, etc.
Using the Lance for corners cleaning (F)
This lance is suitable for thorough cleaning of the more difficult-
to-reach places, like skirting-boards, sofa gaps, armchairs,
upholstered furniture, car seats.
A
A
U
U
T
T
O
O
M
M
A
A
T
T
I
I
C
C
C
C
A
A
B
B
L
L
E
E
W
W
I
I
N
N
D
D
E
E
R
R
Before putting the vacuum cleaner away, rewind the power cable
by pressing the button (8), careful to assist the cable during win-
ding.
U
U
S
S
E
E
O
O
F
F
T
T
H
H
E
E
A
A
C
C
C
C
E
E
S
S
S
S
O
O
R
R
I
I
E
E
S
S
H
H
O
O
L
L
D
D
E
E
R
R
The accessories holder (G1) allows you to fix the tube with the
brush mounted on it on the body of the appliance. To attach the
hose to the appliance, slide the hook (G) on the hose into the
accessories holder slot on the appliance (Fig.6).
G
G
E
E
N
N
E
E
R
R
A
A
L
L
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
C
C
E
E
Always make sure the appliance is unplugged before performing
maintenance work of any kind.
Replacement and cleaning of the Hepa-type filter (12) and
the filter body with fine mesh (13)
Remove the dust container (1) as described in the paragraph
“Emptying and cleaning of the dust container”.
• Remove the filter from the container and separate it as shown
in fig.7.
• Rinse all elements under running water and let them dry.
• Put all elements back in place.
Let the filters dry naturally, away from light and heat sources.
You should wait 24 hours before reassembling filters in the
appliance.
• Replace the filters if they are torn.
• Filters should be cleaned every 4 months.
Do not clean filters with a brush, as this could damage them,
decreasing their filtering capacity.
Do not use detergents, do not scrape filters, and do not wash
them in a dishwasher.
Replacement of the active carbon filter (14)
Open the filter grille (10) by pressing the levers on the grille
itself .
Remove the filter and put in a new one by following the instruc-
tions given above in reverse order.
N.B.: the active carbon filter MUST NOT be washed.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Polti AS-519 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Polti AS-519 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Polti AS-519

Polti AS-519 User Manual - German - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info