637171
1
Zoom out
Zoom in
Previous page
1/2
Next page
ODOBIKE
AVS
MAX
AVS
ODO
MAX
AVS MAX
ODO
R
T
M
D
S
T
CURRENT SPEED • Miles or Kilometers per hour • 0-99.9 mph/Kph • Increments of 0.1 mph/Kph
RIDE TIME, "RTM" • Up to 9:59:59 • Increments of 1 second
RIDE DISTANCE, "DST" • Up to 999.99 M or K • Increments of 0.01 M or K
ODOMETER, "ODO" • Up to 999.99 M or K • Increments of 0.01 M or K
(ODO= Cumulative distance for BIKE 1 and BIKE 2)
1. Parts List
MOUNTING BRACKET
LINE : LCD Specification : Line 1, 2 and 3 modes do not change
1
2
3
4
1
2
3
4
SCREEN:
MOUNTING SENSOR
1
MOUNTING MAGNET (Front Wheel)
2
3
2. Mounting Instructions
3. Functions & Specifications
OR
OR
OR
AVERAGE SPEED, "AVS" • 0-99.9 mph/Kph • Increments of 0.1 mph/Kph
MAXIMUM SPEED, "MAX" • 0-99.9 mph/Kph • Increments of 0.1 mph/Kph
TEMPERATURE • -19˚ to 120˚F/ -19˚ to 50˚C
CLOCK • 12 Hr format • Indicated by flashing colon ":"
BIKE ODOMETER, "BIKE ODO" • Up to 99,999 M or K • Increments of 0.1 M or K
This is the distance for the wheel size currently being used, it only appears when distance is registered
on both BIKE 1 and BIKE 2.
PUSH AND RELEASE FOR
MODE
CHANGE
CAUTION:
HOLD FOR
LESS THAN ONE SECOND
OR YOU WILL RESET ALL
OF THE RIDE DATA
SEE TOP OF
NEXT PAGE.
Thank you for purchasing the Planet Bike Aero Wireless
bicycle computer. Planet Bike will donate 25% of our
profits from this purchase and any other Planet Bike
products you buy to grassroots bicycle advocacy groups
that work to improve conditions for cyclists. Enjoy your
Aero Wireless bicycle
computer and thank
you for making a
difference!
COMPUTER HEAD REMOVAL
STEP 1: Thread the quick ties through the slots in the wheel sensor and attach to the
right or left fork arm so that it is on the same side as the mounting bracket, making
sure that the battery cover is facing the wheel (diagram #1).
STEP 2: Attach magnet to spoke using a screwdriver (diagram #2) so that the
magnet lines up with the top or bottom glossy line on the wheel sensor. Do not
over-tighten magnet screw.
STEP 3: Unthread sensor knob until sensor can swivel freely and rotate the sensor until
it is within 2mm of the magnet (diagram 3). Tighten the knob to fix sensor position.
STEP 4: Attach the computer bracket to the handlebars near the stem (diagram #4).
For 31.8 handlebars, no rubber shim is needed. For smaller diameter handlebars, use the
large shim to achieve a snug fit. Tighten the screw so the bracket will not rotate on
the handlebars. Slide the computer head into the bracket until the latch "snaps" into
place.
STEP 5: Test for proper alignment of the magnet and sensor. First, push the large
mode button located below the screen to activate. Now, spin the front wheel. Speed will
begin to register if the magnet and sensor are properly aligned.
TO REMOVE COMPUTER FROM BRACKET: Push down the bracket latch and
slide the computer forwards off of the bracket (diagram #5).
1. 31.8 mm Mounting Bracket 3. Computer Case
2. Wheel Sensor
5. Wheel Magnet
7. Quick Ties6. Rubber Shims
Line up Sensor
and Magnet at
same level
* Less than
2 mm apart
* DO NOT line
up Magnet
between
GLOSSY LINES
on Sensor.
TURN KNOB
COUNTER
CLOCKWISE
TO ADJUST ANGLE
ODO
AVS
MAX
BIKE
BIKE
BIKE
4. Battery
W I R E L E S S
CHANGE MODE TO SCREEN 2-4 BY PUSHING MODE BUTTON TO ACCESS:
4
Front
of bike
Rear
of bike
5
Front
of bike
Rear
of bike
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Planetbike Aero wireless at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Planetbike Aero wireless in the language / languages: English as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info