494400
71
Zoom out
Zoom in
Previous page
1/75
Next page
Additional information
10
71
En
English Italiano Français
Nederlands
EspañolDeutsch
Considerable noise in radio
broadcasts.
• Tune in the correct frequency.
• Connect the antenna (refer to page 19).
• Route any loose cables away from the antenna terminals and
wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (refer to page 19).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to
page 19).
• Turn off the equipment causing the noise or move it away from the
receiver.
• Move antennas farther away from equipment causing the noise.
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 19).
No sound from surround or
center speakers.
• Refer to
Speaker setting
on page 46 to check the speaker settings.
VSX-D714/D814 only –
Refer to
Manually calibrating your listening
area (MCACC)
on page 52 to check the speaker levels.
• Connect the speakers properly (refer to page 20).
No sound from surround
back speakers
(VSX-D714/
D814 only)
.
• Refer to
Surround back speaker setting
on page 46 to check the
surround back speaker settings.
• Refer to
Manually calibrating your listening area (MCACC)
on
page 52 to check the speaker levels.
• Refer to
Using the Surround Back Channel (SB CH)
on page 39 to
make sure the
SB CH MODE
and the sound mode are set for
surround back sound.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• Switch the
Subwoofer setting
on page 47 to
YES
or
PLUS
.
• Switch the
LFE attenuator setting
on page 47 to
0 dB
or
10 dB
.
• The Dolby Digital or DTS source you are listening to does not have
an LFE channel.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
Sound is produced from
other components, but not
from LD or DVD player.
• Set the
SIGNAL SELECT
to
AUTO
,
DIGITAL
or
ANALOG
according to the type of connections made. (refer to page 38).
• Set the digital input settings correctly (refer to page 50).
• Make digital connections (refer to page 15) and set the
SIGNAL
SELECT
to
DIGITAL
(refer to page 38).
• Refer to the instruction manual supplied with the DVD player.
Problem
Remedy
VSX_514-814.fm 71 ページ 2004年3月2日 火曜日 午後8時35分
71


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer VSX-D814 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer VSX-D814 in the language / languages: English as an attachment in your email.

The manual is 2,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info