670586
5
Zoom out
Zoom in
Previous page
1/7
Next page
5
Installation instructions
Dynamic SoundField
V5.00/2012-06/visu’l/© Phonak AG/All rights reserved/page 5/7
19V
AUDIO
3.2A
19V
AUDIO
3.2A
4) Mount the array fixation on the DigiMaster by using the two black
hex screws and hex wrench 5.
5) Carefully attach the DigiMaster [A] to the wall support and turn it
to face the center of the class.
6) Attach the power cable to the power adapter. Plug the power
cable into the mains and the 19 Volt jack into the socket on the
bottom of the DigiMaster. Your DigiMaster is now ready to be
paired with the inspiro.
Make sure the power cable is safely positioned!
2.2 Mounting DigiMaster on the wall
1) Measure 1.40 meters (4 feet) up from floor level and mark this point
on the wall with a pencil.
Hold the wall support against the wall so that the pencil mark
is at the bottom of the wall support. Adjust the wall support using
the spirit level until it is level. Use the pencil to mark the wall
through the wall support’s four holes.
2) Remove the wall support and drill 4 holes using a 5 mm (0.2 inch)
diameter drill bit. The depth of these holes should be at least
30 mm (1.2 inches).
3) Push the anchors into the holes. Mount the wall support using the
4 torx screws and the torx T20 screwdriver.
Spirit level
Pencil mark
(1.4m / 4 feet above floor level)
Wall support
30 mm
Please check the Dynamic SoundField User Guide to learn about
the standard functions of Dynamic SoundField.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Phonak Dynamic SoundField at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Phonak Dynamic SoundField in the language / languages: English as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Phonak Dynamic SoundField

Phonak Dynamic SoundField Installation Guide - Dutch - 7 pages

Phonak Dynamic SoundField Quick start guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info