450365
226
Zoom out
Zoom in
Previous page
1/232
Next page
1 将小插头插入 Jet Clean 高效能清洁系统。
2 将电源适配器插入电源插座。
, 支架将自动移到最高位置。
3 同时按下清洗仓两侧的释放钮 (1)。然后将 Jet Clean 高效能清洁系统从清洗仓上提起 (2)。 (图 28)
, 留下清洗仓。
4 拧开装清洁剂的瓶子的瓶盖。
5 给清洗仓注入 HQ200 清洁剂,水量在两线之间为宜。 (图 29)
6 将 Jet Clean 高效能清洁系统重新放在清洗仓上。 (图 30)
确保释放键卡回到位。
使用 Jet Clean 高效能清洁系统
注意: 如果您在剃须时使用了剃须泡沫或剃须啫喱,建议您在将剃须刀放入 Jet Clean 高效能清洁系统清洁之前,先在热水龙头下
冲洗干净。这样可以保证清洁剂拥有最佳的使用寿命。
1 将剃须刀倒置放入支架中,让显示屏朝向 Jet Clean 高效能清洁系统的正面。 (图 18)
2 将剃须刀牢固地按入支架,使其锁定到位。 (图 19)
, 显示屏将显示剃须刀正在充电(见“显示屏”一章)。
3 按 Jet Clean 高效能清洁系统上的开/关按钮以启动清洁程序。 (图 31)
, 剃须刀显示屏停止显示充电指示。
, 清洗指示灯开始闪烁,剃须刀将自动降到清洁剂中。 (图 32)
, 清洗指示灯在整个清洗程序中不断闪烁,这需要几分钟时间。
, 在清洗程序的第一个阶段,剃须刀将开关数次,并会向上和向下移动。
, 在清洗程序的第二个阶段,剃须刀处在干燥档位,这由一个闪烁的干燥符号表示。此阶段大约需要 2 小时。在此程序结束之前
剃须刀一直都会处在此档位。 (图 33)
, 清洗程序结束后,充电指示将出现在剃须刀显示屏上(见“显示屏”一章)。
注意: 如果在清洗程序运行期间按 Jet Clean 高效能清洁系统的开/关按钮,则程序将中断。此时,清洗或干燥指示灯将停止闪
烁,支架将回到最高位置。
注意: 如果在清洗程序运行期间将适配器从插座上拔除,则程序将中断。支架将保持在当前位置不变。当您将适配器重新插入插
座时,支架将继续移动到最高的位置。
- 当清洁剂水位下降至最低水位以下时,“清洗仓已空”符号将开始闪烁,支架将返回到起始位置。 (图 34)
- 如果每天都使用清洁器清洗您的剃须刀,则需要大约每 15 天向清洗仓内补充清洁剂一次。
清洁 Jet Clean 高效能清洁系统
每隔 15 天清洁一次清洗仓。
您可以用湿布擦拭 Jet Clean 高效能清洁系统的外表面。
1 同时按下 Jet Clean 高效能清洁系统两侧的释放钮 (1)。然后将 Jet Clean 高效能清洁系统从清洗仓上提起 (2)。 (图 28)
, 留下清洗仓。
2 将清洗仓中残余的清洁剂倒出。 (图 35)
您只需将清洁剂倒入水槽。
3 在水龙头下冲洗清洗仓。 (图 36)
清洗仓不可在洗碗机中清洗。
4 给清洗仓注入 HQ200 清洁剂,注入量在两线之间为宜。 (图 29)
5 将 Jet Clean 高效能清洁系统重新放在清洗仓上。 (图 30)
确保释放键卡回到位。
超彻底清洁方法
确保产品电源已关闭。
1 将剃须刀头支架从剃须刀头部件的底部抽离。 (图 26)
2 按固定架所示的箭头方向滑动绿色固定架。 (图 37)
3 将固定架从剃须刀头支架中提起并取出。 (图 38)
4 将刀片从网罩上取下。 (图 39)
注意: 不要同时清洁多组刀片和网罩,因为它们都是相互匹配的。如果不小心将刀片装到了错误的网罩上,则需要数周时间才能
恢复产品的最佳剃须性能。
5 用随附的清洁刷清洁刀片。 (图 40)
6 清洁网罩的内侧。 (图 41)
7 清洁后,将刀片重新装回至网罩,刀片底部朝下。 (图 42)
8 装固定架装回到剃须刀头支架上。 (图 43)
9 将网罩滑回到位(可听到“咔哒”一声)。 (图 44)
10 将剃须刀头支架重新装回剃须刀头部件的底部。 (图 27)
清洁修发器
每次使用后都要清洁修发器。
1 打开装有修发器的剃须刀。
简体中文226
226


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips Senso Touch 2D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips Senso Touch 2D in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info