51045
29
Zoom out
Zoom in
Previous page
1/32
Next page
27
Poor reception (in analogue mode)
The proximity of high buildings may be
responsible for ghost pictures, echoing or
shadows.In this case, try manually adjusting
your picture:see "fine tuning" (p.6) or change
the orientation of the outside aerial. In the
event of difficult reception (snowy picture)
switch the NOISE.REDUCT on the FEATURES
menu to ON. (p.7).
Bad picture (in digital mode)
If the picture freezes a lot,or in cases of block
effect, there is a problem of poor reception.
Please check with the signal strenght menu
(see p.8).
Depending on the strength of digital terre s t r i a l
signals available in your are a ,s t a n d a rd aerials used
for analogue transmissions will in most cases
p rovide satisfactory reception of digital signals.I n
g e n e r a l ,set top and communal aerials will not
g i ve satisfactory re s u l t s ,best performance and
stability of digital signals can be achieved if a high-
quality aerial and wiring is installed.
If reception problems are experienced with a
s t a n d a r d aerial,a good quality,n a rrow beam
antenna should be pro fe s s i o n a l ly installed outside
the pro p e rty and aligned to cap t u r e the maximu m
digital signal stre n g t h .Loft antenna's can be used
w h e re an outside installation is not possible,
h oweve r,c a re should be taken to mount the loft
antenna as high as possible and as far aw ay fro m
house wiring as possible.Aerial amplifiers should
o n l y be used when absolutely necessary. D o u b l e
s c r een coaxial cable should be installed betwe e n
the aerial and television re c e i ver and positioned to
avoid close proximity to house wiring.T h e
t e l e vision re c e i ver should be connected dire c t ly to
the coaxial cable,rather than routing the signal
first through other pro d u c t s .
No picture
H ave you connected the aerial socket pro p e r ly ?
H ave you chosen the right system? (p.6)
Is the
contrast or the brightness badly adjusted?
Press È to select one of the smart control
presets.
Po o r ly connected euroconnector cables or aerial
s o c k ets are often the cause of picture or sound
p roblems (sometimes the connectors can
become half disconnected if the TV set is move d
or turned).Check all connections.
Picture adjustment
If the picture is not adjusted properly or if you
have trouble obtaining a clear picture,select
one of the smart control presets È (p.8) and
store using the STORE PP ALL function in the
FEATURES menu.
The picture is too blue or too red! Adjust the
TINT (p. 12).
In the event of difficult reception (snowy
picture) switch the NOISE.REDUCT on the
PICTURE menu to ON. (p.12).
Peripheral equipment gives a black and
white picture
You have not selected the right socket with the
X key: E2 instead of E2 Y/C.
To play a video cassette, check that it has been
recorded under the same standard (PAL,
SECAM, NTSC) which can be re p l ayed by the
video re c o rd e r.
No sound (in analogue mode)
If on certain channels you re c e i ve a picture but no
s o u n d ,this means that you do not have the corre c t
TV system. Modify the SYSTEM setting (p. 6 ) .
The left and right loudspeakers on the TV set do
not work? Check that the external loudspeake r s
switch has not been activated by mistake (p. 2 0 ) .
The Surround Sound loudspeakers do not wo r k ?
For them to function corre c t ly it is essential that
both loudspeakers are connected:c h e c k
c o n n e c t i o n s .
If in doubt, use the SOUND LEVEL menu (p.13)
to check each channel.
Remote control
The TV set does not react to the remote
control;the indicator on the set no longer
flashes when you use the remote control?
Replace the batteries.
Press the TV key to be sure your remote
control is in the TV mode
Standby
When you switch the TV set on it remains in
s t a n d by and the indication LOCKED is displaye d
when you use the keys on the TV set? The
CHILD LOCK function is switched on (p.7).
If the set receives no signal for 15 mins, it
automatically goes into standby mode.
The set consumes energy when it is switched
on.To save electricity, we recommend that you
switch the TV set off using the ON/OFF key.
Still no results?
If your TV set breaks down, never attempt to
repair it yourself: contact your dealer's after-
sales service.
Tips
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Philips 28DW6734 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Philips 28DW6734 in the language / languages: English as an attachment in your email.

The manual is 1,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info