770988

Petsafe PIF00-15001 Manual

3
Zoom out
Zoom in
Previous page
1/24
Next page
www.petsafe.net 3
These steps will help keep your pet secure and comfortable. Millions of pets are comfortable while they wear stainless
steel contacts. Some pets are sensitive to contact pressure. You may find after some time that your pet is very tolerant of
the collar. If so, you may relax some of these precautions. It is important to continue daily checks of the contact area. If
redness or sores are found, discontinue use until the skin has fully healed.
• You may need to trim the hair in the area of the Contact Points. Never shave your pet’s neck; this may lead to a
rash or infection.
• Always remove your pet’s Receiver Collar before performing any Transmitter testing.
• The Receiver Collar should not be on your pet when the system is tested. Your pet may receive an unintended correction.
• The Boundary Zone must be tested whenever an adjustment is made to the Transmitter setting to prevent unintended
corrections to your pet.
• If you use a collar and leash for training, be sure the extra collar does not put pressure on the Contact Points.
• To prevent an unintended correction, remove the Receiver Collar from your pet when indoors.
• Never remove power from the system when the collar is on the pet. This may activate the Receiver Collar.
• Radio Systems Corporation recommends the use of an Uninterruptible Power Supply (UPS) for use with your wireless
fence. Should the power go out at your home, your pet will be unprotected. Power outages can be unpredictable,
and the use of a UPS will provide you with some time to properly restrain your pet.
In rare instances, if your pet is near the boundary at the time when the power fails, it is possible that your pet will receive a
correction. This correction will stop after a 15 second timeout period has been reached. This is due to the operation of the
collar: the collar is activated by the absence of the containment signal.
While results will vary depending on the UPS manufacturer’s specifications the following are typical examples to guide
your choice of UPS:
• Using a 400 VA UPS a consumer should expect 3 hours of backup time.
• Using a 900 VA UPS a consumer could expect 8 hours of backup time.
If settings below maximum fence size are used, additional backup time will result. At minimum fence size settings backup
time may be more than two times the backup time estimated at maximum fence size.
• To prevent an unintended correction, after the Boundary Flags have been placed, be sure to set the Static Correction
on the Receiver Collar back to Level 1 Tone Only.
• Do not place anything on the top of the Transmitter or cover any ventilation holes. This may overheat the Transmitter
and cause early transmit failure.
• Do not place Transmitter in a closet or any other confined, unventilated area.
• Do not place Transmitter on a metal surface.
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Petsafe PIF00-15001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Petsafe PIF00-15001 in the language / languages: English as an attachment in your email.

The manual is 2.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info