651202

Peaq PDP070 Manual

26
Zoom out
Zoom in
Previous page
1/84
Next page
ENGLISH
26
•
Refer all servicing to authorised service
agent. Do not attempt to repair the
product yourself. Servicing is required
when the product has been damaged
in any way, such as the supply cord or
plug are damaged, liquid has been spilled,
objects have fallen into the product, the
enclosure is damaged, the product
has been exposed to rain or moisture,
does not operate normally, or has been
dropped.
•
Before connecting the product to a socket
outlet, make sure the voltage indicated
on the product corresponds to your local
mains.
•
If the supply cord is damaged, it must
be replaced by the manufacturer or its
service agent or similarly qualified person
in order to avoid hazard.
•
Regularly check if the supply cord, product
or extension cable is defective. If found
defective, do not put the product into
operation. Immediately pull the plug.
•
Place the supply cord and, if necessary,
an appropriate extension cable in such
away that pulling or tripping over it is
impossible. Do not allow the supply cord
to hang down within easy reach.
•
Do not jam, bend or pull the supply cord
over sharp edges.
• Only use the provided adaptor.
•
The adaptor power plug is used as
the disconnect device; the disconnect
device shall remain readily operable. To
completely disconnect the power input,
disconnect the adaptor power plug.
•
The product may not function properly or
not react to the operation of any control
due to electrostatic discharge. Switch o
and disconnect the appliance; reconnect
after a few seconds.
•
Protect the supply cord from being walked
on or pinched particularly at the plug,
convenience receptacles and the point
where it exits from the product.
•
Never pull the adaptor power plug by the
supply cord or with wet hands.
•
Disconnect the adaptor power plug in
case of faults during use, during lightening
storms, before cleaning and when not
using the product for a longer period
of time.
•
Danger! Before cleaning, switch the
product o and disconnect the adaptor
power plug from the socket.
• When the product has reached the end
of its service life, make it defective by
disconnecting the adaptor power plug
from the socket and cutting the cord
in two.
•
Caution! There is danger of explosion
from improper replacement of the
batteries. Replace batteries only with
the same or equivalent type of battery.
•
Always change the entire battery pack. Do
not mix old and new batteries, or batteries
with dierent charge state.
•
Make sure the batteries are correctly
inserted. Observe the polarity (+) plus / (-)
negative on the battery and the housing.
Improperly inserted batteries can lead to
leakage or, in extreme cases, a fire or an
explosion.
•
Never expose batteries to excessive heat
(e.g. bright sun, fire), and never throw
them into fire. The batteries could explode.
•
The connections must not be short-
circuited.
•
Remove used batteries. Remove the
batteries if you know that the device will
not be used for a longer period of time.
Otherwise, the batteries could leak and
cause damage.
•
Keep batteries out of reach of small
children. If batteries have been swallowed,
seek immediate medical attention.
•
Non-rechargeable batteries must not be
recharged.
•
Remove the batteries from the product
before disposal.
IM_PDP070_150902_V03_HR.indb 26 2/9/15 4:03 PM
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Peaq PDP070 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Peaq PDP070 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info