595406

Parkside PDR A1 - IAN 96959 Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
GBGB
GB
GBGB
of purchase, it will be repaired or replaced
- at our choice - by us free of charge. This
warranty is conditional on the defective de-
vice and the receipt of purchase being pre-
sented within the 3 year warranty period, and
that there is a brief written description of the
nature of the defect and of the date it arose.
If the defect is covered by our warranty, we
will return the repaired equipment or repla-
cement thereof. A repair or exchange of the
equipment does not extend a new warranty
period.
Scope of warranty
The appliance has been manufactured to st
rict
quality guidelines and meticulously examined
before delivery.
The warranty applies to faults in material or
manufacture. This guarantee does not apply
to product parts which are subject to normal
wear and tear and can be regarded as wea-
ring parts, or for damage to breakable parts,
e.g., switch, rechargeable batteries, or parts
which are made of glass.
This warranty becomes void if the device has
been damaged or improperly used or main-
tained. All instructions provided in the ope-
rating instructions must be followed strictly to
constitute proper use of the product. Uses and
actions contrary to those set out in the opera-
ting instructions, and which are ill-advised or
warned against, must be avoided at all cost.
This product is intended for private, non-com-
mercial use only. Any incorrect or improper
use of the device, use of force and changes
not performed by our authorized service
branch will void the warranty.
Procedure in the case of
warranty
Please follow the instructions below to ensure
quick processing of your claim:
Please retain proof of purchase and the arti-
cle number (e.g., IAN). The product number
can be found on the type plate, an engraving,
the cover page of your instructions (bottom
left) or the decal at the back or bottom. In
the event of malfunctions or other defects
please first contact the service department
below by phone or e-mail. A product recor-
ded as defective, along with the proof of
purchase (sales receipt) and a description
of the defect and when it occurred, can
then be returned free of charge to you to
the service address provided.
How to contact us:
GB
Name: C. M. C. GmbH
Website: www.cmc-creative.de
E-mail:
service.gb@cmc-creative.de
Phone: 0-808-189-0652
(Standard German land-
line charges)
Registered office: Germany
IAN 96959
Please note that the following address is not
a service address.
Please initially contact the named Service
Centres.
Address:
C. M. C. GmbH
Katharina-Loth-Str. 15
66386 St. Ingbert
Germany
Environmental instructions
and disposal information
Don‘t waste, recycle!
Device, accessories and packa-
ging should be recycled in an
environmentally friendly manner.
Do not dispose of the air tool with your house-
hold waste, or throw into fire or water.
If possible, non-operational equipment should
Start-up
Before first use
Remove the battery compartment lid
9
on the rear.
Replace with battery type LR 03 AAA
1.5 V. Check the polarity of the batteries.
Close the battery compartment
10
by
replacing the battery compartment lid
9
.
Connecting the
compressed air source
Warning: Never exceed the maximum
permitted operating pressure of 6.2 bar.
Warning: In order to regulate the pres-
sure, the compressed air source must be fit-
ted with a pressure regulator.
Connect the unit to a suitablecompres-
sed air source. Now connect the supply
pipe using the quick-release connector to
the coupling plug on the pneumatic tyre
inflator.
Using the pneumatic
tyre inflator
Connect the unit to a compressed air
supply and press the On / Off switch
3
on the pneumatic tyre inflator display
4
. The unit is now activated.
Press the trigger
8
to start the air flow.
Release the trigger
8
to stop the air
flow. The air pressure can be read off
the pressure gauge
1
.
Using the FUNC button
2
you can
switch between the various measuring
units (PSI, bar, kPa, Kgf,/cm
2
).
If you have inflated too much air into the
article: Press the air release button
5
to release some of the air.
Press the lever down on the valve plug
and pull off the valve cap from the valve.
Disconnect the unit from the compres-
sed air source after finishing the work.
Warning: First of all, disconnect the tube
from the compressor and when you have
done this, disconnect the supply pipe from
the unit. Following these instructions will
stop the supply pipe from twirling around
all over the place.
Changing the batteries
Remove the battery compartment lid
9
on the rear.
Remove the used batteries.
Replace with battery type LR 03 AAA
1.5 V. Check the polarity of the batteries.
Close the battery compartment
10
by
replacing the battery compartment lid
9
.
M
aintenance and Cleaning
DANGER OF IN-
JURY! The device requires no maintenance.
Do not use corrosive or aggressive cle-
aning agents. Do not allow any liquids
to enter the device. Otherwise the de-
vice could be damaged.
Clean the casing with a dry cloth.
Service
Only allow your unit to be maintained and
serviced by qualified service personnel. This
will maintain the safety features of your unit.
Warranty
Creative Marketing Consulting
GmbH warranty
Dear customer, the warranty for this device
is 3 years from the date of purchase. In the
event of product defects you have legal rights
against the retailer of this product. Your sta-
tutory rights are not limited in any way by
our warranty detailed below.
Warranty terms
The warranty period begins on the date of
purchase. Please retain the original receipt
safely. This document is required as your
proof of purchase.
Should this device show any fault in materi-
als or manufacture within 3 years from date
Safety information
Basic safety measures
must be followed when using compressed
air devices to eliminate the risk of fire, electric
shock and personal injury. Be sure to read
and follow the notices within these opera-
ting instructions prior to using the equipment
and store them in a safe location. The ma-
nufacturer assumes no liability for damages
or personal injury resulting from failure to
follow these operating instructions.
Children or persons who lack the know-
ledge or experience to use the device or
whose physical, sensory or intellectual
capacities are limited must never be
allowed to use the device without su-
pervision or instruction by a person re-
sponsible for their safety. Please ensure
that children cannot play with this unit.
Check the unit after
filling with compressed air using a te-
sted pressure gauge.
EXPLO-
SION HAZARD! Use this
device in well-ventilated areas
only. Never use petrol or other flamma-
ble liquids to clean the air tool! Sparks
could ignite residual vapours inside the
compressed air equipment resulting in the
compressed air equipment exploding.
RECOIL! When used
under high pressure conditions, recoil
can occur which can cause danger due
to constant pressurisation.
RISK OF INJURY!
Never point the air jet towards yourself
or other people, animals, or electrical
equipment.
During maintenance, switch off the
compressed air supply.
Never exceed the maximum permitted
operating pressure of 6.2 bar. Use a
pressure reducer to adjust the operating
pressure.
Switch the device off if you do not use it
anymore.
First of all, disconnect the tube from the
compressed air source and when you
have done this, disconnect the supply
pipe from the unit. Following these in-
structions will stop the supply pipe from
twirling around all over the place.
For your own protection, please wear
suitable protective clothing.
Keep children and other persons away
from the equipment during use.
Do not use the equipment when tired or
under the influence of drugs, alcohol or
medications. One moment of careles
sness
when using the equipment may result in
serious injuries. Distractions can cause
you to lose control of the device.
Before any repair and maintenance
work or transport, remove the device
from the compressed air source.
Before using the unit, check it for da
mage,
and especially for light damage or da-
mage to the protective systems. These
must be thoroughly checked to confirm
that they are indeed completely capa-
ble of performing their intended tasks.
All unit parts must be correctly assembled
and comply with all guidelines in order
to ensure correct and safe operation.
If you ascertain that the unit is indeed
damaged, you are not permitted to use
it. Do not bend the unit’s pipe. This could
cause damage.
Warning! Please observe all manu-
facturer’s instructions regarding inflatable
articles.
Never remove model numbers. They
are safety-relevant parts of the unit. If
you have no experience of working with
this unit, please undertake a training
course to acquaint you with the dan-
gers of embarking on such a venture.
Original Accessories /
Auxiliary equipment
Use only the accessories and attachments
detailed in the operating instructions.
Using other types of additional parts
can cause danger.
Pneumatic tyre inflator PDRD A1
Introduction
Congratulations!
You have chosen high-quality de-
vice by our company. Familiarise
yourself with the product before using it for
the first time. In addition, please carefully
refer to the operating instructions and the
safety advice below. Initial operation of this
tool must be performed by trained person-
nel. Keep these instructions in a safe place.
If you pass the device on to anyone else,
please ensure that you also pass on all the
documentation.
Intended use
With suitable accessories the pneumatic
tyre inflator can be used to pump up and
regulate the air pressure in bicycle tyres, in-
flatable dinghies, air beds, balls, etc. This
article is not to be used contrary to the stip-
ulated conditions of intended use detailed
in the instruction leaflet. The manufacturer
accepts no responsibility for damage or in-
jury resulting from non-observance of the in-
structions or from any form of misuse. This
device has been designed for household
use and may not be used for commercial or
industrial purposes.
Features
1
Pressure gauge
2
FUNC. Button
3
On / Off button
4
Pneumatic tyre inflator
5
Air outlet button
6
Compressed air nozzle
7
Tube with valve plug
8
Trigger
9
Battery compartment cover
10
Battery compartment
Scope of delivery
1 Digital pneumatic tyre inflator
1 Set of operating instructions
Technical Data
Operating pressure: max. 6.2 bar
Rated voltage range: 3 V
Compressed air quality: Cleansed, oil-free
and free of con-
densation
Volume flow: Standard flow:
100–300 l / min.
Sound pressure level: 86 dB (A)
Acoustic capacity: 98 dB (A)
Measured value
Corresponds to: EN ISO 14462
The display is powered by 2 LR 03 AAA 1.5 V
batteries that are stored behind the display
(approx. 3 years operational durabilty).
Should the display fade or work incorrectly,
please replace the batteries.
C. M. C. GmbH
Katharina-Loth-Str . 15
66386 St. Ingbert
Germany
Stand der Informationen · Stand van de
informatie · Last Information Update: 06 / 2014
Ident.-No.: PDRDA1062014-DE / AT / NL
be recycled. Contact your local retailer for
information.
EU Conformity
Declaration
We,
C. M. C. GmbH
Responsible for documentation:
Markus Zimmer
Katharina-Loth-Str. 15
66386 St. Ingbert
declare in our sole responsibility that the
product
Pneumatic tyre inflator
Serial number: 1713
Year of manufacture: 2014 / 32
IAN: 96959
Model: PARKSIDE PNEUMATIC TYRE
INFLATOR PDRD A1
Complies with the following EU norms,
guidelines and directives:
Machinery Directive
(2006 / 42 / EC)
RoHS Directive
(2011 / 65 / EC)
EMV Directive
(2004 / 108 / EG)
applicable harmonised standards
DIN EN 1953:2013
DIN EN 61010-1:2010
DIN 31000:2011-05
St. Ingbert, 30.06.2014
Karl Peter Uhle
- Managing Director -
The following pictograms are used in these operating instructions /
on the equipment:
Please read the operating
instructions!
Never point the device at people
or animals.
Observe the warning and
safety instructions!
Keep children away from the
device!
Wear ear protection, dust
mask, safety glasses and
protective gloves.
Dispose of packaging and device
in an environmentally-friendly way!
Direct current
96959_par_Druckluft-Reifenfueller_(600x630)_DE_AT_NL.indd 2 05.06.14 15:43
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PDR A1 - IAN 96959 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PDR A1 - IAN 96959 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Parkside PDR A1 - IAN 96959

Parkside PDR A1 - IAN 96959 User Manual - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info