568793

Paradigm PT-1 Wireless Transmitter Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
LED STATUS
WIRE CONNECTION
WIRELESS SYNC INSTRUCTIONS (cont’d)
WIRELESS SYNC INSTRUCTIONS
LATENCY SWITCH INSTRUCTIONS
Off: No power.
Fast blinking: Set-up mode.
Dim: Unit in standby mode, no transmission.
Slow blinking, ‘off’ to bright: Waking from standby mode
and synching.
Slow blinking, dim to bright: At least one subwoofer is synched.
Permanently On: All subwoofers synched and receiving signal.
1. Plug in PT-1 wireless transmitter.
2. Press and hold sync button on rear panel of PT-1 for 3 seconds.
The LED will blink quickly.
3. Within 60 secs of pressing the sync button all subwoofers must
be plugged in. Once all subwoofers are synched, the LED will
remain ‘on’.
The latency switch adjusts the delay between the PT-1’s audio
signal input and the subwoofer receiver’s RF output, optimizing
integrity of the wireless transmission. Start with the switch in the
15ms position. If you experience sound quality issues (i.e drop-outs,
pops, ticks), you can improve the connection by moving the switch
to 20ms or 25ms to increase latency.
RECYCLING AND REUSE GUIDELINES FOR EUROPE
In accordance with the European Union WEEE (Waste Electrical
and Electronic Equipment) directive effective August 13, 2005,
we would like to notify you that this product may contain regulated
materials which, upon disposal, according to the WEEE directive,
require special reuse and recycling processing. For this reason Paradigm
Electronics Inc. (manufacturers of Paradigm speakers and Anthem
electronics) has arranged with our distributors in European Union
member nations to collect and recycle this product at no cost to you.
To find your local distributor please contact the dealer from whom you
purchased this product or go to our website at www.paradigm.com.
Please note that the product only falls under the WEEE directive. When
disposing of packaging and other shipping material we encourage you
to recycle through the normal channels.
This device contains FCC ID: YZY-HT205 and IC ID: 9261A-
HT205. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
cause undesired operation.
LATENCY (ms)
15 20 25
SYNC
INPUT: 7. 5V
250mA
—
---
SUB-IN
- -
-
-
+
+
+
+
Sub-Out
L
Paradigm
Wireless
Subwoofer
Receiver
LR
R
LATENCY (ms)
15 20 25
SYNC
INPUT: 7. 5V
250mA
—
---
SUB-IN
- -
-
-
+
+
+
+
Sub-Out
L
Paradigm
Wireless
Subwoofer
Receiver
LR
R
LATENCY (ms)
15 20 25
SYNC
INPUT: 7. 5V
250mA
—
---
SUB-IN
- -
-
-
+
+
+
+
Sub-Out
L
Paradigm
Wireless
Subwoofer
Receiver
LR
R
All subwoofers must be unplugged from outlets.
TIPS!
Once all subwoofers have been synched, if necessary they can be
unplugged and moved without resynching again.
To minimize the chance of signal dropouts or signal interference,
keep the PT-1 transmitter out of range of a microwave oven, mobile
telephone or a Bluetooth device operating on the same frequency
ABOUT YOUR PT-1 TRANSMITTER
In a typical listening room the PT-1 transmitter has a maximum range
of 50’ (15 m). Obstructions such as walls, large pieces of furniture,
room dividers, etc., may reduce this range. Do not place subwoofer(s)
and transmitter farther apart than the recommended range. The PT-1
is a 2.4 GHz digital design that automatically adjusts for best wireless
connection while constantly monitoring the integrity of the data
stream. An RCA audio cable is required (not included) to connect it to
your A/V receiver or preamplifier (see dealer).
One PT-1 transmitter can be used with up to four wireless Paradigm
subwoofers. See dealer for details on connecting multiple subwoofers.
LATENCY (ms)
15 20 25
SYNC
INPUT: 7. 5V
250mA
—
---
SUB-IN
A
A
B
B
C
C
PT-1_Transmitter Manual_EN.indd 2 13-04-05 3:26 PM
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Paradigm PT-1 Wireless Transmitter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Paradigm PT-1 Wireless Transmitter in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Paradigm PT-1 Wireless Transmitter

Paradigm PT-1 Wireless Transmitter User Manual - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info