563932
17
Zoom out
Zoom in
Previous page
1/20
Next page
17
VQT4Z19
If the playback stops, check the playback status on the
iOS device or iTunes.
If play does not start (even though “ ” is displayed), restart
the wireless network router, turn the Wi-Fi connection on the
iOS device or Mac/PC off and on, and then make sure that
your home wireless network is selected.
With some iOS and iTunes versions, it may not be possible
to restart the AirPlay playback if the selector is changed
(e.g., “CD”) or this system is turned off, during the AirPlay
playback. In this case, select a different device from the
AirPlay icon of the Music App or iTunes and then re-select
this system as the output speakers. (
>
9)
“--:--”
You connected the AC mains lead for the first time or
there was a power failure recently. Set the clock.
“Adjust CLOCK”
Clock is not set. Adjust the clock accordingly.
“Adjust TIMER”
Play timer is not set. Adjust the play timer accordingly.
“Auto Off”
The unit has been left unused for about 20 minutes and will
shut down in a minute. Press any button to cancel it.
“CANNOT SET”
Select an audio source other than “AirPlay”,
“BLUETOOTH” or “DLNA”.
“Checking Connection”
The unit is checking the connected iPod/iPhone/iPad.
If this display keeps appearing, make sure that iPod/
iPhone/iPad is inserted correctly and try again.
“DL Error”
The software download has failed. Press any button to
exit. Please try again later.
The server cannot be found. Press any button to exit. Make
sure that the wireless network is connected to the Internet.
“Error
An incorrect operation was done. Read the instructions
and try again.
“F61” or “F76”
There is a power supply problem.
“Fail”
Updating or setting has failed. Read the instructions
and try again.
“iPod_Dock Over Current Error”
“iPod_Port Over Current Error”
The iPod/iPhone/iPad or USB device is drawing too
much power. Remove the iPod/iPhone/iPad or USB
device. Switch the system off and on again.
“Level 0”
There is no link between this system and the wireless
network router.
Try the following operations:
jCheck that the wireless network router is turned on.
jTurn this system off and on again.
jReset the wireless network settings. (> 6)
If the problem persists, consult your dealer.
“Level j
When “D.Connect” is set to “On” the Wi-Fi signal strength
cannot be checked. To check the Wi-Fi signal strength from
the wireless network router, set “D.Connect” to “Off”. (
>
10)
“Linking”
This system is communicating with the wireless network
router to complete the network settings.
Depending on the wireless network router this process
may take a few minutes. Try moving this system closer
to the wireless network router.
“No Connect”
This system cannot connect to the network.
Check the network connection. (> 6)
“No Device”
The iPod/iPhone/iPad or USB device is not connected.
Examine the connection.
“No Disc”
You have not put in a disc or put in a disc that the
system cannot play.
“No Memory”
There are no preset DAB/DAB+ stations to select.
Preset some channels.
“No Play”
Examine the content. You can only play supported format.
If there are more than 255 albums or folders (audio and
non-audio), some of the MP3
/FLAC files in these
albums cannot be read and played. Transfer these
music albums to another USB device. Alternatively,
reformat the USB device and save these music albums
prior to saving the other non-audio folders.
“No Signal”
This station cannot be received. Check your antenna.
“Not MP3/Error”
An unsupported MP3 format. The system will skip that
track and play the next one.
“Not Supported”
You have inserted an iPod/iPhone/iPad that cannot be played.
Switch off the iPod/iPhone/iPad and the system before you connect
the iPod/iPhone/iPad. Connect the iPod/iPhone/iPad and try again.
This message may be displayed when a wireless LAN
connection is made without unlocking the iPod/iPhone/
iPad. (> 7, “Method 2”)
“PGM Full”
The number of programmed tracks is more than 24.
“Reading”
The unit is checking the disc and USB device information.
After this display has disappeared, start operating.
“Scan Failed”
Stations are not receivable. Check your antenna and try
DAB manual tuning.
“Set Wi-Fi”
The connected iPod touch/iPhone/iPad is not connected
to a wireless network. Connect it to a wireless network
and try again. (> 6)
“Wait”
This is displayed, for example, when this unit is turned
off. (For up to 1 minute and 30 seconds)
Reset the memory when the following situations occur:
There is no response when buttons are pressed.
You want to clear and reset the memory contents.
1 Disconnect the AC mains lead.
Wait 3 minutes before you continue with step 2.
2 While you press and hold [Í/I] on the main unit,
connect the AC mains lead again.
“- - - - - - - - - - - -” is shown.
3 Release [Í/I].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
To set the code to “Remote 2”
1 Press [CD] to select “CD”.
2 Press and hold [CD] on the main unit and [2] on
the remote control until “Remote 2” is shown.
3 Press and hold [OK] and [2] for a minimum of
4 seconds.
The factory preset is “Remote 1”.
To change the mode back to “Remote 1”, repeat the
steps above but replace the button pressed on the
remote control from [2] to [1].
Main unit displays
Memory reset (initialisation)
Remote control code
SC-PMX9-VQT4Z19.book 17 ページ 2013年3月21日 木曜日 午後4時16分
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic SC-PMX9DB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic SC-PMX9DB in the language / languages: English as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic SC-PMX9DB

Panasonic SC-PMX9DB Quick start guide - English - 1 pages

Panasonic SC-PMX9DB Quick start guide - German - 1 pages

Panasonic SC-PMX9DB User Manual - German, Dutch - 84 pages

Panasonic SC-PMX9DB Quick start guide - Dutch - 1 pages

Panasonic SC-PMX9DB User Manual - Danish - 64 pages

Panasonic SC-PMX9DB Quick start guide - Danish - 1 pages

Panasonic SC-PMX9DB Quick start guide - French - 1 pages

Panasonic SC-PMX9DB User Manual - French - 84 pages

Panasonic SC-PMX9DB Quick start guide - Italian - 1 pages

Panasonic SC-PMX9DB User Manual - Italian - 84 pages

Panasonic SC-PMX9DB Quick start guide - Swedish - 1 pages

Panasonic SC-PMX9DB User Manual - Swedish - 64 pages

Panasonic SC-PMX9DB Quick start guide - Finnish - 1 pages

Panasonic SC-PMX9DB User Manual - Finnish - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info