407518
3
Zoom out
Zoom in
Previous page
1/8
Next page
RQT6744
3
1
Switch [ ] to “TUNER”.
(Unit comes on.)
2
Press [BAND] to select “FM” or “AM”.
3
(Omit this step if using the remote control)
If “ ” is on the display, press
[TUNE MODE] to clear it off.
4
Press [–/g] or [f/+] to
tune to the desired station.
The frequency changes one step
each time a button is pressed.
Automatic tuning
Keep [–/
g] or [f/+] depressed and release when the frequency
display starts to change. A station with good reception is automati-
cally selected and the process stops.
To stop automatic tuning, press [–/
g] or [f/+] again.
Note
Automatic tuning may stop on a frequency where there is no station if
there is interference. Press [–/
g] and [f/+] to tune if this occurs.
5
Adjust the volume.
To use auto scan
You can search for a station by listening to all tuned-in stations for 8
seconds each.
Preparation: Switch [
] to “TUNER”.
1. Press [BAND] to select “FM” or “AM”.
2. Press [AUTO SCAN].
Auto scan starts.
3. Press [AUTO SCAN] when you find the desired station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To improve reception
FM: Extend the whip antenna and adjust its direction.
AM: Adjust facing of the unit.
If noise is excessive in the FM stereo mode
Press [FM MODE]. (“
” lights up.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. (“
” goes out.)
Preset the stations (twelve FM and twelve AM) to make tuning simpler.
Preparation: Tune to the desired station.
(Do steps 14 on the left.)
1
Press [MEMORY].
2
While “ ” and the frequency are
flashing
Press [MEMORY].
3
While “ ” and the preset channel
are flashing
Press [–/g] or [f/+] to
select the desired channel.
(Remote control: [
44
44
4] or [
33
33
3])
4
Press [MEMORY].
(This completes presetting.)
Repeat the above to preset other stations.
Note
If “
” goes off during presetting, return to step 1.
Press [BAND] to select “FM” or “AM”.
(Omit this step if using the remote control)
Press [TUNE MODE] to display
”.
Press [–/
g] or [f/+] to select
the desired channel (1–12).
(Remote control: [
44
44
4] or [
33
33
3])
To use preset scan
You can search for a station by listening to all preset channels for 8
seconds each.
1. Do steps to above.
For remote control, replace [– /
g] or [f/+] described below with [
44
44
4]
or [
33
33
3].
2. Press and hold [–/
g] or [f/+] until “PS” appears on the display.
3. Press [–/
g] or [f/+] when you find the desired channel.
Preset scan ends after searching through each preset channel once.
To stop during the process, press [–/
g] or [f/+].
Normal tuning Preset tuning
The Radio
To listen to preset channels
How to preset
Indicates
auto scan
Indicates
preset scan
” lights when an FM stereo
broadcast is being received.
Preset channel
Preset channel
3
2
15 4
1
2
3
124 3
P3-4 11/20/02, 11:25 AM3
3


Need help? Post your question in this forum.

Forumrules
1

Forum

panasonic-rx-d21-eg-a

Reset search

  • Panasonic RX-D21 showingUOI ON SCREEN AND WONT PLAY WHEN PLUGGED IN ,NO BATTERIES IN. Submitted on 13-5-2020 at 12:48

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic rx d21 eg a at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic rx d21 eg a in the language / languages: English as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic rx d21 eg a

Panasonic rx d21 eg a User Manual - German - 16 pages

Panasonic rx d21 eg a User Manual - German, Dutch, Danish - 16 pages

Panasonic rx d21 eg a User Manual - French - 16 pages

Panasonic rx d21 eg a User Manual - French - 16 pages

Panasonic rx d21 eg a User Manual - Italian - 16 pages

Panasonic rx d21 eg a User Manual - Italian, Swedish - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info