627468
36
Zoom out
Zoom in
Previous page
1/40
Next page
Others
-7
0
-
Extremely high precision technology is
employed to produce the Viewfinder screen
featuring a total of approximately 113,000
pixels. The result is more than 99.99% effective
pixels with a mere 0.01% of the pixels inactive
or always lit. However, this is not a malfunction
and does not affect the recorded picture.
Lens Hood
Do not attach other conversion lenses in front
of the Lens Hood; there is no mount to be
used for the attachment.
When you wish to attach the Wide Conversion
Lens (VW-LW4307ME; optional), MC
Protector, or ND Filter in the Filter Kit
(VW-LF43WE; optional), first of all, loosen the
Lens Hood Attachment knob 1. If the MC
Protector or ND Filter is used, the Lens Hood
can be mounted on the filter.
When you attach the Lens Hood back, unite
the marks and fasten the Lens Hood
Attachment knob 1.
If you push the [W/T] Lever toward [W] during
recording with the filter or conversion lens
attached to the Movie Camera, 4 corners of
the image may become dark (vignetting). For
details, please refer to the operating
instructions of your accessories.
Be sure to keep the Lens Hood attached to the
Movie Camera so as to shut out unnecessary
light.
Before Requesting Repair
(Problems and Solutions)
Power
1:The Movie Camera power cannot be
turned on.
Is the power source connected correctly?
(
-42-
)
2:The Movie Camera power is turned off
automatically.
If you leave the Movie Camera in Recording
Pause Mode for more than 6 minutes, the
power is turned off automatically to protect
the tape and to save the Battery power. (
-48-
)
3:The Movie Camera power does not stay on
long enough.
Is the Battery low? Charge the Battery or
attach a fully charged Battery. (
-42-
)
Has condensation occurred? Wait until the
Condensation Indication disappears. (
-68-
)
Battery
1:Battery runs down quickly.
Is the Battery fully charged? Charge it with
the AC Adaptor. (
-42-
)
Are you using the Battery in an extremely cold
place? In cold places, the operating time of
the Battery becomes shorter. (
-69-
)
1
Has the Battery worn out? If the operating
time is still too short even after the Battery is
fully charged, the Battery has worn out.
2:The Battery cannot be charged.
If the DC Input Lead is connected to the AC
Adaptor, charging cannot be performed.
Disconnect the DC Input Lead.
Normal Recording
1:Recording does not start although power
is supplied to the Movie Camera and the
Cassette is correctly inserted.
Is the accidental erasure prevention slider on
the Cassette open? If it is open (set to
[SAVE]), recording cannot be performed.
(
-44-
)
Is the tape wound to the end? Insert a new
Cassette. (
-43-
)
Is the Movie Camera power turned on? (
-48-
)
Is the [CAMERA] Lamp on? If the [CAMERA]
Lamp is not on, no recording function can be
operated. (
-48-
)
Has condensation occurred? Wait until the
Condensation Indication disappears. (
-68-
)
Other Recording
1:Auto Focus Function does not work.
Is Manual Focus Mode selected? If Auto
Focus Mode is selected, focus is
automatically adjusted. (
-54-
)
There are some recording subjects and
recording surroundings for which the Auto
Focus Function does not operate correctly. In
this case, use the Manual Focus Mode to
adjust the focus. (
-71-
)
Editing
1:Audio dubbing cannot be performed.
Is the accidental erasure prevention slider on
the Cassette open? If it is open (set to
[SAVE]), recording cannot be performed.
(
-44-
)
Are you attempting to edit a tape portion that
was recorded in LP Mode? LP Mode does not
allow audio dubbing to operate. (
-47-
)
Indications
1:The Time Code becomes inaccurate.
The Time Code Indication counter may not be
constant in the reverse direction in Slow
Motion Playback Mode, but this is not a
malfunction.
2:The Remaining Tape Time Indication
disappears.
When you record still pictures in Photoshot
Mode, the Remaining Tape Time Indication
may disappear temporarily. However, it
reappears when recording normally.
3:The Remaining Tape Time Indication does
not match the actual remaining tape time.
If scenes of less than 15 seconds are
continuously recorded, the remaining tape
time cannot be displayed correctly.
In some cases, the Remaining Tape Time
Indication may show remaining tape time that
is 2 to 3 minutes shorter than the actual
remaining tape time.
Playback (Pictures)
1:Pictures cannot be played back even when
the [1] Button is pressed.
Is the [VCR] Lamp on? If the [VCR] Lamp is
not on, the playback function cannot be used.
(
-57-
)
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NVMD9000EN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NVMD9000EN in the language / languages: English as an attachment in your email.

The manual is 3,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info